Summary of Contents for Golight HELIOS
- Page 1 HELIOS (Heat Enhanced Low-Light Imaging Observation System) Instruction Manual 37146 Old Hwy 17 | Culbertson, NE 69024 308.278.3131 | www.golight.com | info@golight.com...
-
Page 3: Table Of Contents
Warnings Table of Contents The Helios complies with Part. 15.105 of the FCC Rules. This equipment has been tested and found to comply with the limits for a Class B digital device. These limits are designed to provide reasonable protection against harmful Introduction: Overview . -
Page 4: Introduction: Overview
It is also available with PAL output by special order. before performing these functions. Failure to do so may result in an accident. The Helios features a wide field-of-view and is capable of providing an image Consult your local and state driving regulations prior to installation. -
Page 5: Introduction: Getting Started
Power Consumption: 2 Watts (nominal) 8 Watts with heater turned on Using your Helios Environmental The Helios is easy to use, but you should take a moment to carefully read this Operating Temperature: -40˚C to +80˚C section so you fully understand what you are seeing on your display. While... -
Page 6: General Information
Initial System Startup Wired Dash Mount Toggle With Cover The Helios camera requires power and a connection to an external monitor to provide imagery. Make sure to test the system prior to installation to assure the system is functioning properly. Be sure to remove the protective window sticker prior to test and installation. -
Page 7: Warranty Information
Fasten the stainless steel mounting plate with the included mounting screws; dling to : Golight, Inc • 37146 Old Hwy 17 • Culbertson, NE 69024. No C.O.D.’s 3 ea. #10-16x3/4 type AB cross recessed pan head tapping screws. Finish the accepted. -
Page 8: About The Product
The frozen image will display a small white box in the left middle portion of the image during this calibration. In Case of Difficulty The Helios comes with a 12 month limited warranty from the date of purchase. DO... -
Page 9: Troubleshooting
First pull the camera backwards, then NOT OPEN, MODIFY, or ALTER the Helios unit or accessories. Doing so will void any seat the back of the camera on to the mounting plate. Displace the back of warranty and may cause system malfunction, loss of performance, fire, or bodily harm. -
Page 10: Parts List
Wireless Remote System Also, verify the Helios is connected to the 75 ohm input on the monitor. The image may be dim if the camera is connected to an input that requires a dif- Determine the location for the system on your vehicle or boat. Locate the ferent impedance.
Need help?
Do you have a question about the HELIOS and is the answer not in the manual?
Questions and answers