Skuttle Indoor Air Quality Products 2000 Installation Instructions Manual
High-capacity bypass flow-thru humidifiers with side entry
Hide thumbs
Also See for 2000:
- Owner's manual (52 pages) ,
- Owner's manual (8 pages) ,
- Owner's manual (8 pages)
Advertisement
Advertisement
Table of Contents
Related Manuals for Skuttle Indoor Air Quality Products 2000
Summary of Contents for Skuttle Indoor Air Quality Products 2000
-
Page 1: Installation Instructions
Installation Instructions for Models 2000, 2100, 2001 and 2101 High-Capacity Bypass Flow-Thru Humidifiers with Side Entry Inside Front Cover Contractor: Read these instructions before installing or servicing humidifier. ©Skuttle Mfg. Co. 2008 000-0756-336 E-Web 9/08 (for English) -
Page 2: Warnings And Cautions
Email: techservice@skuttle.com Web: www.goskuttle.com Skuttle and the “Happy House” character are registered trademarks of Skuttle Mfg. Co. (DBA Skuttle Indoor Air Quality Products) Warnings and Cautions WARNING: This high-capacity flow-thru humidifier must be installed by a qualified heating and air conditioning contractor. Failure to comply could result in serious injury from electrical shock, damage humidifier or heating appliance, and/or void all warranties. - Page 3 Placement: Skuttle num. Connect the Connect the unit to unit to the cold air the warm air return 2000- and 2100-Series return using 6 in. using 6 in. (15.24 Flow-Thru Humidifiers (15.24 cm) round cm) round duct.
- Page 4 5. Pull out the drip tray and evaporator pad NOTE: Photos shown here and on the assembly by grasping following pages are of the Skuttle 2000/ the top lip and tipping 2100 Flow-Thru Humidifier. The 2001/2101 out. unit is somewhat larger, however, instal- lation procedures for all four models are identical unless otherwise noted.
- Page 5 Compustat automatic humidifier control. 120 volt, connect the transformer to the terminals and wire as shown in Diagram C 13. TO WIRE MODEL on page 4. ) 2000 OR 2001 AND THE HUMIDISTAT... Wiring Diagram A shut off the furnace Terminals on Board power.
- Page 6 Step-by-Step Installation Instructions (cont’d.) 13B. For multi-speed blowers or systems not Wiring Diagram C using 120 VAC, use an Single-Speed Blower A50 Electronic Relay or other method of coordinating humidifier operation with the system air mover. The source of power for the humidifier transformer should not be the blower motor wiring, but an independent source.
- Page 7 Make sure the brackets are parallel, then Tighten the bottom clamp evenly, making tighten the screws evenly and firmly. sure that the brackets are parallel. Connect the water line to the saddle valve Turn the saddle valve handle clockwise ( ) outlet.
- Page 8 101 Margaret Street • Marietta, OH 45750 800-848-9786 • 740-373-9169 customerservice@skuttle.com • www.goskuttle.com...
Need help?
Do you have a question about the 2000 and is the answer not in the manual?
Questions and answers