Chevrolet Corvette 2014 Owner's Manual page 209

StabiliTrak activates when the
vehicle senses a difference between
the intended path and the direction
the vehicle is actually traveling.
StabiliTrak selectively applies
braking pressure to any one of the
vehicle wheel brakes to assist the
driver in keeping the vehicle on the
intended path.
If cruise control is being used when
TCS begins to limit wheel spin, the
cruise control will automatically
disengage. Cruise control may be
reengaged when road conditions
allow. See Cruise Control on
page 9-47.
Both systems come on
automatically when the vehicle is
started and begins to move. The
systems may be heard or felt while
they are operating or while
performing diagnostic checks. This
is normal and does not mean there
is a problem with the vehicle.
It is recommended to leave both
systems on for normal driving
conditions, but it may be necessary
to turn TCS off if the vehicle gets
stuck in sand, mud, ice, or snow.
See If the Vehicle Is Stuck on
page 9-13 and Turning the
Systems Off and On later in this
section.
The indicator light for both systems
is in the instrument cluster. This
light will:
Flash when TCS is limiting
wheel spin.
Flash when StabiliTrak is
activated.
Turn on and stay on when either
system is not working.
Driving and Operating
If either system fails to turn on or to
activate, a message displays in the
Driver Information Center (DIC), and
comes on and stays on to
indicate that the system is inactive
and is not assisting the driver in
maintaining control. The vehicle is
safe to drive, but driving should be
adjusted accordingly.
If comes on and stays on:
1. Stop the vehicle.
2. Turn the engine off and wait
15 seconds.
3. Start the engine.
Drive the vehicle. If
and stays on, the vehicle may need
more time to diagnose the problem.
If the condition persists, see your
dealer.
9-37
comes on