Insignia NS-MB2600W-C Quick Setup Manual

PACKAGE CONTENTS

• Mobile Battery Pack
• Micro USB Charging Cable
• Quick Setup Guide
CHARGING THE MOBILE BATTERY
Fully charge your mobile battery pack before using it for the first
time.
1 Plug the small end of the included USB cable into the battery
pack's microUSB port (input).
2 Plug the large end of the USB cable (included) into a standard
USB port on your computer, vehicle charger, or wall charger
(not included).
The battery pack automatically begins charging.
Before using your new product,
please read these instructions to prevent any damage.
LEDs
Battery Indicator Button
Micro USB (Input)
Quick Setup Guide
CHARGING YOUR ELECTRONIC DEVICE
USB (Output)
1 Plug the large end of the USB cable into the battery pack's
USB port (output).
2 Plug the small end of the USB cable into your device.
The battery pack automatically begins charging your device.
Recharge the battery pack when the LED starts blinking.
Note: If your device requires a different connector than the one
provided, use the cable that came with your device.
CHECKING YOUR BATTERY LEVEL
Press the battery indicator button to check your battery level:
• • • •
4 LEDs = 75-100%
• • • •
3 LEDs = 50-75% power
• • • •
2 LEDs = 25-50% power
• • • •
1 LED = 0-25% power
Blinking LED = <10% power
|
NS-MB2600W-C / NS-MB2600B-C
Mobile Battery Pack
power