Winy technology Bravo 16 GB Quick Manual

BRAVO Quick Guide
Please read below introduction carefully before using.
1. Please check any defects on the product before installation. We are not responsible for any cost or expense
incurred, as a result of the failure to check before installation.
2.
If the constant power discharge protection function is set 'ON', motion detection will work as parking
REC mode. If the vehicle battery voltage becomes lower than setting value of cut off voltage, a recording
will stop even parking REC mode.
3. Please format a Micro SD card every other week, as it may cause recording error, storing video file error and
playback error.
4. Below table is Recordable Time by "SD card Folder Capacity Adjustment"and"Video Quality"based on the
default setting.
Image
CH Camera
Quality
Normal(50%)
Super High Front 130
1CH High Front 174
Normal Front 262
Super High Front/Rear 141
2CH High Front/Rear 176
Normal Front/Rear 265
By time: When the memory is full, the oldest file will be automatically deleted.
By mode: Total record files are stored by your setting rate on "SD card Folder Capacity Adjustment".
When memory is full on a particular recording mode, the oldest file will be automatically deleted on
particular recording mode. Stored file may also be deleted.
5.
The Micro SD card is a consumable goods. Aged SD card may cause error. Please replace the periodically.
(In general, the warranty period for a Micro SD card for car recorder is 6 months.)
6. When an accident occurred, please power off the product, remove the Micro SD card and save the accident file on
your PC. If long time passed after accident and the file will be deleted, we are not responsible for missing the file.
Package
Rear Camera
Micro SD Card
BRAVO
Option
Accessories
16GB 32GB
Event(30%) Motion(20%) Normal(50%) Event(30%) Motion(20%)
78 51 266 158
105 69 353 212
157 104 531 318
83 55 285 168
104 69 356 211
161 107 535 325
Rear Camera Video Cable Cigar Lighter
SD card Adaptor Cable Clip
GPS Module
Null Cable
(Option)
(Option)
How to use
Front Camera Installation
When use the Null cable, please check the fuse is normally. (Some Fuses are different depend of the type of vehicle.)
105
Rear Camera Installation
141
212
111
140
216
(Unit : Minute)
During recording, the product may be affected by wireless devices such as radio frequency,
DMB signal, remote start device, remote controller etc. Install as far away from the antenna
and antenna cable as possible; and when cabling or tidying up cables, please avoiding the cables to be duplicated.
External GPS Module Installation
GPS module may be affected by main body or by other electronic devices if it is too close each other.
Bracket
Keep a distance as much as possible.
The receiving signal may become poor depending on the climate, satellite status and geography in the neighborhood.
The receiving signal may become poor if the windshield is heavy sun-coated or fixed with metallic materials.
TV-Out Cable Installation
Extra 3M tape
AV – OUT Cable When connecting to your vehicle Navigation, you need an applied vehicle Navigation video cable. With a specific
(Option) Vehicle Navigation, installation may be restricted, and/or extra service charge may be incurred.
1. 2.
Insert the Micro SD Remove the protect
Card to BRAVO sticker.
card slot.
(Check the direction)
4. Attach the BRAVO 5. Connect the Cigar
in place on the top Lighter to Cigar
of front windshield Socket
or middle o left and
right of the mirror.
1. Shutdown a v ehicle 2. Remove a protect
battery and power sticker and attach a rear
off BRAVO first camera in proper
before installing location in windshield.
a rear camera.
(Disconnect the
power connection)
4. Connect a rear 5. After connecting a
camera jack(smaller power/video cable,
side) to a rear camera Please check the
and a another jack recorded image that
(bigger side) to is stored in Micro SD
PLAY
R-CAM connection. card if BRAVO can
record properly.
Connect External GPS
to GPS connection on
BRAVO body.
Connect a TV-Out
cable to the TV-Out
jack on a BRAVO body.
3.
Connect Cigar lighter
cable to Power
connection of product.
6. Arrange a power cable.
3. After attached a rear
camera, adjust an
angle. Adjust angle is
e right angle to lens
face or little downward
facing.
6. After checking recording
operation, well arrange
a cable.
If you embed cable to
vehicle wall, please
check cable connection.
Also after embedded
double-check if BRAVO
can record properly
Attach GPS module
at well visual place
and tidy up a cable.
Connect a TV-Out cable
to AV-IN jack your vehicle
navigation.