5. Music Use; 6. Phone Use; 7. Wired Use - Puro Sound Labs BT2200 User Manual

PURO Sound Labs BT2200 USER MANUAL v 1.1
Bluetooth button will need to be held for 3 seconds to re-enter "discoverable"
mode, indicated by the fast flashing BLUE LED.
4.3) Bring the source device within 1 meter of the headphone. Follow the source
device instructions to look for discoverable devices. Select "PURO BT2200" from
the list. You will hear a long high-tone beep when pairing is complete and the
LED will change from a fast flashing blue to a slow flash blue. The headset is
ready for music or phone use.
BLUE fast LED flash = in pairing mode
BLUE slow LED flash = paired
5.) Music Use
5.1) Choose media to playback and adjust the volume to your desired level.
5.2) Place the headset on your (or your child's head), the size can be adjusted by
pulling the "arms" down or pushing them back into the "headband"
5.3) The Bluetooth button can be used to pause and resume playback of music.
5.4) The Vol+ and Vol- buttons can be pressed or held to adjust volume to the desired
level.
6.) Phone Use
Initiate calls on your mobile handset. Music playback will be paused for the duration of the
call. A short press of the Bluetooth button will end the phone call.
For incoming calls, a tone will sound on the Bluetooth headset.
A short press of the Bluetooth button will answer the call.
A one second press of the Bluetooth button will reject the call. Hold the Bluetooth
button until a tone is heard, then release.
A three second press of the Bluetooth button will transfer the call back to the
handset. Another three second press while the phone call is underway will return the call
to the headset.
7.) Wired Use
Wired use may be necessary in the following circumstances:
a.) The battery has been depleted.
b.) No Bluetooth connection is available on the source device.
c.) Use of wireless radios is restricted.
To use the wired connection, identify the end nearest to the limiter housing, this is a plastic
housing attached to the cable. Attach the limiter housing end to the headphone and the
other end to the source device's 3.5mm headphone jack.
When returning to wireless use, remove the 3.5mm cable.
Puro Sound Labs, LLC • CONFIDENTIAL • 2014 All Rights Reserved • Do Not Distribute
1/4/15
5