Advertisement
HOW TO OPERATE THE UNIT
If you want to circulate room air only, you must set the unit to FAN.
If you want to heat your room, you must set the unit to HEAT.
FAN: To circulate room air, set the AUTO/MAN switch to MAN
and use the Temperature dial to adjust the amount of airflow.
The AUTO mode is not used in the FAN setting.
HEAT: To heat your room, you can operate the unit either
automatically in the AUTO mode or manually in the MAN mode.
• In AUTO: Set the Temperature dial to a desired setting between
50°F and 80°F . The unit will automatically adjust the heat output
as the room gets warm or cold.
• In MAN: Set the Temperature dial to a desired setting between
50°F and 80°F . The unit will continue to run at that setting until
you turn the dial to a higher or lower setting. In this setting you
may change the heat output but the unit does not sense the
room temperature.
How the Automatic Temperature Control Works:
When in the AUTO mode, the Cabin Furnace's automatic
temperature control monitors the changes in the room's
temperature and adjusts the heat output without cycling on
and off. As your room gets warmer, the heat will gradually
cut down to a lower wattage level. As your room gets
colder, the heat will gradually increase to a higher wattage
level. This is a more effective and a more efficient means of
heating than conventional thermostats that create noisy
on/off cycling and hot/cold spells.
6
West Marine Ceramic Disc Cabin Furnace
Advertisement
