Kenwood SVT-M700 Service Manual page 7

• Preparation
1. Prepare the H/U (STC-700) and the NAVI unit (KNA-DV2200/S), and connect the power cord and the interface cord to it.
2. Prepare the remote controller (RC-DV100), and the operation mode selector switch is made the television mode.
1. Touch panel adjustment, Screen display start position and Flicker Confirmation
Item
1. Touch panel adjustment 1. While pressing and holding VOL DOWN and SOURCE keys, reset
2. Screen display start
position confirmation
VR200
3-1. Flicker confirmation
VR302
3-2. Flicker confirmation
VR302
2. X35 UNIT Adjustment
Item
1. IC200 Free run
frequency adjustment
VR201
ADJUSTMENT
Adjustment method/Adjustment value
the unit. Boot up the system in Test mode.
2. Recall the TOUCH PANEL ADJUST screen by pressing SRC key of
the remote controller.
3. Press at the center section of a cross-cursor (+) font on the screen
by using adjustment tool (upper left → upper right → lower left).
4. When the writing of EEPROM is executed correctly, the buzzer
generates 2 beeps. If the writing of EEPROM is not executed
correctly, the buzzer generates 4 beeps.
(Note.1) When conducting the adjustment for the first time, the display
position of the cross-cursor (+) may be a little off, but the
djustment should be conducted by using the center section of
a cross-cursor (+) font.
(Note.2) If the adjustment becomes impossible as a result of having
input incorrect values, clear the EEPROM data first and then
conduct the adjustment.
1. With the OSD (RADIO SETTINGS) screen, confirm that the 3
vertical lines of A and B part is to be inside the end of the screen.
TP SETTINGS
RADIO
FM1
AUTO1
AM LIST
1 2
2. If they are a little off, adjust the 3 vertical lines of A and B part to be
inside the end of the screen by using VR200.
If the difference is much too large, adjust from the beginning of X35
UNIT.
1. Connect the NAVI unit and display the NAVI screen.
2. With a NAVI screen, confirm there is no flickering (Easy to read
characters in the NAVI screen).
3. If the flickering is recognized, adjust VR302 so that the flicker level
will be the minimum.
1. Input the Composite Gray RASTA [NTSC] signal.
2. Adjust VR302 so that the flicker level will be the minimum.
Adjustment method/Adjustment value
1. Connect the check land (TP47 or TP133) to GND line.
2. Adjust VR201 so that HSY (TP48 or TP131) frequency is set to
15,734Hz ± 10Hz.
3. Release the connection between the check land and GND line.
A
TP
98.1 MHz
NO RDS
FM
PTY
PTY
B
3 4 5 6
SVT-M700
Conditions
• Must be in test mode.
• Remote controller(RC-
DV100)
• Remote sensor jig
(Refer to Attention of
page 11)
• Adjustment tool (with
smaller tips of
approximately 0.2mm in
diameter)
• Input signal : OSD
(RADIO SETTINGS)
• Input signal : NAVI RGB
signals
• Must be in test mode.
• Input signal : Composite
input Gray RASTA
[NTSC] (Easy to read
level of white 30~50%)
Conditions
• Input : Video in no
signal
7