Connect The Interconnection Cable To Radar Interface Box - Navico Broadband 4G Installation Manual

12 |
Installation | Broadband 3G/4G™ Radar Installation Guide

Connect the interconnection cable to radar interface box

To connect interconnection cable to Lowrance HDS
MARPA)" on page 14)
D
F E
G
H
1. Slide (F), (E) and (D) over the RJ45 and data
wires of the scanner interconnection cable (G)
A
H
D
4. Secure (D) to the radar interface box using
the four supplied M3x12 black s/s screws (H)
A
F
6. Rotate (F) clockwise to secure. Firmly tighten
by hand only
• To remove the scanner interconnection cable, follow the above procedure in reverse order
• To avoid damaging the connectors when removing the scanner interconnection cable, it
is important to remove the cable gland washer before trying to remove the cable gland
housing
(USA only)
A
B
C
2. Connect data wires to the green terminal
block (phoenix connector)
3. Connect RJ45 and phoenix connector to
the radar interface box
5. Slide (E) along the cable (G) and press into
the cable gland housing (D)
A
B
C
D
E
F
G
H
(see "Lowrance: HDS USA (no
Data
Shield
Black
Yellow
Red
E D
Radar interface box
Radar data connector RJ45
Power wires (see "Connect power"
on page 18)
Cable gland housing
Gland washer
Lock nut
scanner interconnection cable
Screws x 4 M3x12 mm Phillips pan
head