Figure 18 - Single Row Of Westinghouse Solar Modules Installed - Westinghouse AC System Installation Manual

Westinghouse Solar AC Installation Guide
tightening down the 3/8" Flange nut against the L Bracket Once the array has been leveled, double
check all flange nuts and lags are properly secured.

Figure 18 - Single row of Westinghouse Solar modules installed

Considerations for Wiring Westinghouse Solar AC Arrays with multiple rows
If your array is continuing to an upper row, prepare the last wiring harness connector in the first
row with an Extension Cable that will reach the upper row modules bulkhead connection.
Westinghouse Solar AC Extension Cables are available in a length of 6', 12' and 20'.
Tip: Careful planning of wiring layouts will create a quick installation without interruptions or the
need to purchase additional equipment.
Installing a Second Row of Modules
To install a second row of modules in the north-south direction, Westinghouse Solar North-South
Brackets are used as a structural component to connect module frames in adjacent rows. North-
South Brackets balance the load of both rows on a shared attachment point in the center of the
array.
Copyright © 2011 - Westinghouse Solar 27 | P a g e