Advertisement
Quick Links
Advertisement
Summary of Contents for Guardian G-2 CS
- Page 1 GUARDIAN G-2 CS Stainless Steel Printer Enclosure Enclosure Instructions 46709...
-
Page 2: Table Of Contents
Contents Installation ..........................1 Open Guardian G-2 CS Cover ................... 1 Install the Power Unit Supply ..................1 Remove the Cable Sealing Plate ................1 Set the Printer into Enclosure ..................1 Close Cover ........................ 2 Enclosure Options ........................2 Attaching the Terminal Block .................. -
Page 3: Remove The Cable Sealing Plate
1.1 Open Guardian G-2 CS Cover adhesive cable mount. To open the Guardian G-2 CS cover, release the four butterfly latches located at the bottom four corners of the enclosure. Push down on the enclosure to fully open the latches. -
Page 4: Installing The Heating Unit
2.0 Enclosure Options wire jumper to the ground stud located next to the printer power switch. Be sure the wires are securely Optional features of the Guardian G-2 CS Printer positioned between the two stud nuts. Attach the other enclosure include:... -
Page 5: Installing The Axial Ventilating Fan
5. Rinse printer by splashing with cold water. 4.0 Warranty The Guardian G-2 CS is covered by Rice Lake Weighing Systems standard product limited warranty. Please refer to the Electronic Replacement Parts & Components catalog for further information. - Page 6 Axial Ventilating Fan Power Supply Bracket Terminal Block Protective Warning Shield Power Supply Unit Heating Unit Cable Sealing Plate Ground Stud Nuts Cable Mounts Base...