Contents: Page 1: Overview Page 2: Quick Start Guide Page 3: What do I need to order? Page 4: Operating Options Page 5: Blue Top Order Form Page 6: Lock Connection Page 7: System Wiring schematic Page 8: Wiring Power Supply Page 9: Wiring Power Supply Page 10: Wiring of Opening Devices Page 11: Transponder Set...
Blue Top Locking System Overview This document is designed to be a brief version of the full Blue Top Operators Manual. For any further or more comprehensive Information please refer to the manual or contact; Winkhaus UK Ltd. 1950 Kettering Parkway, Kettering, Northants.
Blue Top Locking System Quick Start Item Description number Blue Top Security Locking System Lock motor Dead Bolt keep Centre keep Actuation Magnet Manual Override operating levers Transformer Battery back up unit Access control Fob reader Terminal block (Auxiliary interface)
Blue Top Locking System What do I need to order: Basic Equipment Supplier Blue Top Security Locking System Blue Top keep set Magnetic Bush Mains power supply to Transformer A n other Transformer Auxiliary Power supply (battery back-up) optional Terminal block (Auxiliary Interface) and lock connecting cable...
Blue Top Locking System Operating Options Operating Equipment outside (select one of the following) Transponder Set Otherwise know as Proximity or key fob system, this system works simply presenting the small key fob to within 20-30mm of the reader unit (located on the wall adjacent to the door) the reader then reads the unique code built into the key fob and unlocks the door.
Blue Top Locking System Lock connection • The grey 4 core lock connecting cable should be one end plugged into the lock motor housing via the blue male connector. • The other end wired into the Terminal block (Auxiliary Interface) using the appropriate colour...
Blue Top Locking System System Wiring schematic The black terminal block (Auxiliary interface) is into which all wires are connected: Item Description number Battery Back up unit 24vdc Transformer Transponder reader Terminal block (Auxiliary interface) 8.1 & 8.2 Cable and lock connector...
Blue Top Locking System Wiring Power Supply (Fail Safe) (using no battery back up) Run a 5amp x 240v fused spur to within 50mtrs of door Connect fused spur to WH Transformer (see diag 1) Connect transformer to BM/BT terminal block...
Blue Top Locking System Wiring of Opening Devices Day Night Function Should during the day you not require the actuation of the dead bolts, the lock can be switched so that the dead bolts remain retracted. To use this facility, you wire a simple single pole rocker switch to terminals 9 &...
Blue Top Locking System Transponder Set Programming and deleting key fobs Programming Key fobs Present the Green programming card to the reader unit, you will then hear short beeps every 0.5 secs. In this mode you can programme up to 250 key fobs by simply presenting them to the reader unit.
Blue Top Locking System Sender Remote Set Programming The set of 3 wireless hand-held remotes have already been programmed to button A. In order to actuate the lock , press the A button of the remote. The red LED will light and the door will begin its operation.
Blue Top Locking System Trouble Shooting When the door is operating correctly, shortly after it has completed the locking sequence, you should hear two short beeps only. If not refer to the chart below: Symptom Cause Remedial action 4 short beeps Operating forces too high, faulty Check Air gap/keep alignment etc.
Need help?
Do you have a question about the Blue Top Locking System and is the answer not in the manual?
Questions and answers