Related Manuals for Scorpion Group Security KD673
Summary of Contents for Scorpion Group Security KD673
- Page 1 DVR QUICK START Scorpion Group Security - 01452 525397 Please read instructions thoroughly before operation and retain it for future reference. KD673_672_671_670_quick_V0.9...
-
Page 2: Special Notes
1. SPECIAL NOTES VGA Output Resolution Support Model 1 and Model 2 have VGA interface built-in, and users are allowed to change the resolution depending on their display monitor. Go to “ADVANCE” “DIAPLAY”, and move to “VGA OUTPUT” to select the VGA resolution you want. There are seven options as follows: 1) 800 x 600 2) 1024 x 768 (default) -
Page 3: Rear Panel
16CH: Press to show the 4 / 9 / 16 channel display modes. 8CH: Press to show the 4 / 9 channel display modes. 4CH: Press to show the 4 channel display mode. 8) SEQ Press to activate the call monitor function, and press again to quit. 9) POWER Press long enough to turn on/off your DVR. - Page 4 INPUT: Connect to video sources, such as cameras. Note: If you want to make a video backup with audio, please make sure whether your DVR supports the audio function, and connect audio cameras to the channels which support the audio function. 3) MONITOR Connect to MAIN monitor for video output.
-
Page 5: Connection And Setup
3. CONNECTION AND SETUP 3.1. HDD Installation The HDD must be installed before the DVR is turned on. Step 1: Loose the screws on the upper cover and open the upper cover of the DVR. Step 2: Remove the HDD bracket. Step 3: Get a compatible HDD, and connect it to the power connector and data bus connector (make sure to align the HDD precisely for pin connection). -
Page 6: Record Setting
setting menu. In the “ADVANCE” menu, Move to “SYSTEM” or “SYSTEM INFO”. Select “PASSWORD” and press “ENTER” to enter the submenu to set the password (four digits). The default admin password is 0000. 3.7. Record Setting By defaults, the record function is activated when the DVR is powered on and a camera is connected. To change the record settings, Press “MENU”... - Page 7 (recording) on the screen. Event Recording Icon When the motion / alarm detection is activated, once motion or external alarm happens, you will see “ ” (motion) or “ ” (external alarm) on the screen. Timer Recording Icon When the timer record is activated, you will see the LCD light of “Timer” is on, and “ ”...
-
Page 8: Firmware / Osd Upgrade
ALARM List the information of the alarm-trigger-recorded files. (Selected models only) MANUAL List the information of the manual-recorded files. The DVR will save one recorded file once any recording setting is changed. MOTION List the information of the motion-trigger-recorded files. SYSTEM List the information of the system-recorded files.