Data Interface The ergo_run classic can be remote controlled by a personal computer (PC). Introduction The serial cable provided is needed for this operation.
Do not jump on to or from the belt while it is running. Do not jump to the front. The user manual should be kept within reach of the ergo_run classic. Do not stand still on the belt while it is running. To dot turn around on the belt It is to be considered an integral part of the device.
In the case of a detected, or even only suspected, fault or defect, the treadmill The ergo_run classic must be connected to a 230Volt 50 Hz AC socket outlet. must be put out of service for safety reasons, and clear visible sign must This outlet must be protected by a 16 amperes fuse (C type).
Safety hints Alternating current Accessories The documentation supplied is an integral part of the ergo_run classic and Protective cable connection may only be copied or distributed with the authorisation of daum electronic Ground gmbh. The device may only be used with the accessories prescribed and distributed Dispose of electrical and electronic old devices by daum electronic gmbh.
In general daum training devices are delivered by a forwarding company. The device must be installed in a horizontal position and may not “wobble”. Daum electronic gmbh is a member of the organisation: “Der grüne Punkt – The feet must be adjusted accordingly and must absolutely have a steady Duales System Deutschland GmbH.”...
Using the device Folding / unfolding Disassembling the handrails The treadmill is shipped folded to save place. Three gas pressure springs If the device happens to be too bulky upon delivery (for instance if it would not support the folding mechanism for ease of use and safety. This makes unfol- pass through a door), it is possible to disassemble the handrails.
Please read the safety notes before switching the treadmill ergometer on. The ergo_run classic is equipped with an Emergency Stop Safety Rope. This Use the green On/Off switch „ O / I „ on the front motor cover lower of the rope guarantees that when the user/patient is about to fall, or when the user/ device to switch it on and off.
Using the device Heart rate measurement Ear Pulse Rate Measure Ear clip Every heart pulse modulates the light passing through the lobe, and can thus be detected by an infrared sensor in the ear clip, and displayed as heart pulse rate.
RS232 PC connector Used to connect a serial cable. When connecting a USB to serial adapter be careful not to have screw connector on the serial side, otherwise you must use a serial cable or the cable supplied by daum electronic.
The dashboard 18 0 19 . 5 ♥ km/h Display window 1 Display window 2 Display window 3 Circular display: Heart rate: Speed: The lap number is shown and the actual position Indicates the heart rate. Indicates the actual speed. blinks.
Dashboard User Guide Using the menu Function key fitness Fitness key: Evaluating the fitness mark (see page 25) Function key: used to control the menu Switch the setting value for heart rate program. Turning the control button: info Info key: Information about the operation of the menu. Pressing the info key during a training displays actual training Selects a menu option and program data.
Dashboard User Guide User data Menu Settings Turn and Turn and User data press press Turn and Training User data Physical data control button control button press Training data Device data Limit values Press the to select to select control button Settings Erase Menu key...
Dashboard User Guide Device data Turn Menu Settings Turn and Device data and press press Turn and Training User data control button Date control button press to select the Training data Device data Time Press the to select control button “Settings Settings Contrast...
Dashboard User Guide Training Turn Dashboard prog.: You can choose from built-in programs, your Menu Training and press own programs, and manual training Turn Training control button Dashboard prog. and press to select the Card prog. Training data Card prog.: Select one of your own programs from the card, Press the control button...
Dashboard User Guide Programs overview Watt programs Program 1 WA - Active Lady 40 - 25 min, max. 110 Program 2 WB - Cool Down - 20 min, max. 150 W Program 3 WC - Pyramid - 45 min, max. 135 W Program 4 WT - Progress - 10 min, max.
Page 18
Dashboard User Guide Program 9 SA - Endurance - 30 min, max. 8.5 kmh Program 10 SA - Walking 03 - 20 min, max. 6.0 kmh Program 11 SB - Endurance - 45 min, max. 10.0 kmh Program 12 SB - Interval - 30 min, max. 9.0 kmh Program 13 SB - Walking 03 - 30 min, max.
Page 19
Dashboard User Guide Program 15 SC - Interval - 60 min, max. 15.0 kmh Program 16 SC - Steps - 40 min, max. 14.0 kmh Program 17 Conconi performance test SpeedPlus Program 26 EA - Walking - 30 min, max. 7 kmh, max. 6% Program 27 EB - Speed Jogging - 35 min, max.
Page 20
Dashboard User Guide Heart rate programs Program 29 PA - Basic HF- 60 min, max. 140 PPM Program 30 PA - Endurance - 25 min, max. 125 PPM Program 31 PA - Endurance - 30 min, max. 140 PPM Program 32 PA - Interval - 40 min, max.
Page 21
Dashboard User Guide Program 35 PB - Interval - 60 min, max. 160 PPM Height profile Program 52 D - Styria - Trofaiach 1 - 7.5 km Program 53 D - The Alps - Kaiserau - 16.4 km Program 54 D - Half Marathon - 21.0 km...
Dashboard User Guide Creating your own programs Each user can create one of each a speed program, a heart rate program, and a watt program on the dashboard. Users No. 1 to 3 can create programs with a duration of up to 60 minutes. User No.
Dashboard User Guide Card programs Please configure your card with the ergo_win software on your computer be- fore you start training with an ergo_memo-card1 (personal data entry). Training with the ergo_memo-card1: Use the card to execute a personal training program that you created on the card using the computer and the ergo_win software.
Dashboard User Guide Calling the Relax-Function Turn Turn Menu Training and press and press control button Training Dashboard prog. control button to select the to select the Training data Card prog. Press the “Training” “Relax” Settings Relax Menu key option option Informations menu...
Dashboard User Guide Fitness Test and Fitness Mark The fitness test can be executed anytime during training. A pulse rate measuring device (ear clip, or chest belt) must be connected and functional, and the training should had already started at least 10 minutes earlier. The measurement principle is based on the fact that the pulse rate falls faster within one minute (following a load period) for well-trained users than for less trained users.
Menu Diagram 1.1.1.1 Built in programs 1. Training 1.1.1.2 Personal Prog. 1.1 Dashboard Prog. 1.1.1 Speed. 1.1.1.3 Manual 1.1.2.1 Built in programs 1.1.2.2 Personal Prog. 1.1.2 Heart rate 1.2 Card Prog. 1.1.2.3 Manual menu 1.1.3 Elevation profile 1.3 Relax 1.1.4.1 Built in programs 1.1.4 Watt 1.1.4.2 Personal Prog.
Page 27
Menu Diagram 3.1.1.1 Birth date 3.1.1.2 Gender 3.1 Personal data 3.1.1 Physical data 3. Settings 3.1.1.3 Size 3.1.1.4 Inclination 3.1.1.5 Weight 3.1.2 Limit values 3.1.2.1 Fat content. menu 3.1.2.2 Speed 3.1.2.3 Watt 3.1.2.4 Heart rate 3.1.3 Delete 3.1.2.5 Training time 3.1.2.6 Distance 3.1.2.7 Phys.
EC Declaration of conformity EC Declaration of Conformity We declare under our sole responsibility that the product: treadmill ergometer model: ergo_run classic article number: 9070080 complies with all applicable requirements of the following prescriptions: 2006/42/EG Machinery Directive 2004/108/EG EMC Electromagnetic Compatibility...
Specifications Technical Safety Recommendations: EMERGENCY STOP: 2 EMERGENCY STOP Systems EMERGENCY STOP button and Compare the supply voltage indicated on the nameplate located on the EMERGENCY STOP safety rope housing with your local supply voltage prior to plugging the power cord to the Running surface: 1.5 x 0.5m foldable power supply.
If the cause of the failure could not be identified, you should contact the The fuse is located close to the power switch (ON/OFF) on the lower front dealer, where you bought the machine, or daum electronic gmbh. part of the treadmill.
Tables and Diagrams Table of Target Heart Rate / Aerobic Zone Example: Heart rate - target zone as a percentage of maximum pulse rate with age limit set up. Aerobic Zone Danger Zone up to 59% 60%-75% 76%-85% 86%-100% 40 - 119 120 - 150 151 - 170 171 - 200...
Accessories (included with the machine) EMERGENCY-STOP safety rope Serial data cable Before starting the training the user must attach the clothes peg of the safety Connecting to a PC. rope to his clothing. Whenever the safety rope is pulled out the running belt Serial data cable will automatically stop.
Accessories (sold separately) ergo_memo-card1 Cardio Sensor Chest Belt When this card is inserted in the dashboard, detailed training data are The chest belt contains a wireless transmitter that transmits the heart rate to automatically saved on the ergo_memo-card1. Individual training instructions the Cardio pulse rate receiver in the device.
Optional software ergo_win premium pro PC Software (EWPP) Daum ergo_win premium pro connects training partners worldwide. With a PC and via Internet it is now possible to work out with friends, similarly minded persons, and training specialists – using a web cam and headset it is also possible to communicate with image and sound.
If you wish to obtain more information on your device, you can visit our service and repair hints web site on Internet at (www.daum-electro- nic.de). You can also call us on our hotline at daum electronic gmbh (++49(0)911/97536-0).
Need help?
Do you have a question about the ergo_run classic and is the answer not in the manual?
Questions and answers