Table of Contents
Advertisement
Wiring and installation
3. Insert the system into the panel cut-out from the front
In order to ensure the protection class IP65 on the front after installation, the
contact surface with the seal must be clean and flush.
4. Ensure the vertical and horizontal alignment of the system
5. Fasten the system from the rear using the mounting clamps
6. Hook the mounting clamps with screws from the rear side of the panel into the
corresponding pairs of slots of the enclosure
The system must be attached firmly with the screws. Tighten the screws with a
torque of 0.5•Nm.
42
Advertisement
Table of Contents
