Advertisement
INSTALLATION GUIDE
1. Preliminary Information
Before you get started make sure these items are included in your Joicekit package:
Also make sure you have
Start by checking that you have a functioning internet connection. Your ISP will give you
instructions for this. The Black Box can be connected to the internet via a network cable or a
wireless connection (WLAN). We recommend connection using a network cable.
2. Connecting up
Please connect up the Joicekit in the order shown below.
Joicebox
Black Box
USB Camera
Antenna
Two Power Adaptors
SCART cable
: Internet Connection
: Subscription for myJoice
Advertisement
Table of Contents
Summary of Contents for Joice Joicekit
-
Page 1: Installation Guide
INSTALLATION GUIDE 1. Preliminary Information Before you get started make sure these items are included in your Joicekit package: Joicebox Black Box USB Camera Antenna Two Power Adaptors SCART cable Also make sure you have : Internet Connection : Subscription for myJoice Start by checking that you have a functioning internet connection. - Page 2 Insert the network cable or attach the WLAN antenna, depending on whether a wired or wireless network connection will be used. Plug in the SCART cable (the cable with the wide connectors at the end) to the socket on Set Top Box with the picture above it and connect the other end to the TV If necessary: If you already have a device connected to the TV's SCART input, disconnect it and plug it in the Black Box's right hand SCART socket (the one without the picture above it)
- Page 3 At this point, the tabletop unit lights will flash on and off for a few minutes and then a picture should appear on the TV screen. If it does not then; If the Black Box has a central green light on and the flashing lights on the tabletop have stopped then try manually switching your TV between the different AV inputs until you see the picture.
- Page 4 You should have received an email from myJoice giving a user name and password. The password is fairly long and uses both numbers and letters. In order to access the myJoice service and make calls you need to input your user name and password using the on screen keyboard and navigating using the buttons indicated.
- Page 5 After learning how to turn the TV on and off you may have to teach the Joicebox how to put the TV onto the input used by the Joicebox. Most users will not need this section since most modern TVs in Europe can automatically switch to the correct input. If your TV cannot automatically switch to the correct input then you may need to 'teach' Joicebox a sequence of TV remote control commands so that it can swicthes the TV to the right input.
- Page 6 4. Settings and Operation After the TV learning sequence the installation is completed and you can turn the Joicebox on in the calling mode and start to make calls. You should be able to find the user Welcome screen. You will want to make a test call to be sure everything is working but first you will need to tell myJoice which calling partners you want to be able to call.
- Page 7 on the left and the picture from the far end camera on the right. You can press the 'Hide Me/Show Me' button to avoid sending your own camera's picture to the far end. Pressing again restarts sending the picture. You can also press the left arrow button successively to see alternative screen views - after four presses you will get back to the starting, default alternative.
-
Page 8: General Information
If at some point you need to go back to the Settings screen to make some changes, then press and hold for 6 or more seconds the button at the rear of your Joicebox (near the wifi antenna position). The screen above will appear and you can go into settings using the navigation buttons and select.
Need help?
Do you have a question about the Joicekit and is the answer not in the manual?
Questions and answers