Unpacking And Testing Appliance; Grounding Appliance; Installation - Ortech OD-B50LED Important Instructions & Operating Manual

UNPACKING AND TESTING APPLIANCE

Carefully remove the appliance from the box. Prior to installing the appliance, test to make sure the
appliance operates properly by plugging the power supply cord into a conveniently located 110-120 Volt
grounded outlet.

【Grounding Appliance】

This appliance is for use on 120 Volts. The cord has a plug
as shown in (A). An adapter as shown in (C) is available
for connecting three-blade grounding type plugs to two-slot
receptacles. The green grounding lug extending from the
adapter must be connected to a permanent ground such as
a properly grounded outlet box. The adapter should not be
used if a three-slot grounded receptacle is available.
To disconnect appliance, turn controls to off, then remove
plug from outlet.
WARNING:
Keep the front of the appliance through which the heat is
radiated at least 1 meter away from furniture, curtains and
other flammable objects at all time.
Never use an extension lead. The mains cable must remain
at the back of the appliance and must not be in contact with
any hot elements.

【INSTALLATION】

ALWAYS unplug this fireplace heater before assembly or cleaning, or before relocating.
Failure to do so could result in electric shock, fire, or personal injury.
Warning
Using the Philips Screw Driver"+" to take off the two screws in the front two sides Figure (A), then
have two people to take off the Glass Panel Figure (B)
2