Mounting Instruction - Accudart eX3000 Instructions And Rules

UNPACKING THE GAME
Unpack your new dartboard carefully, making sure all parts are included.
components are included in this set:
 1 Electronic Dartboard
 6 Darts (unassembled)
 Soft tip replacement pack
 Owner‟s Manual
Choose a location to hang the dartboard where there is about 10 feet of open space in front
of the board. The "toe-line" should be 7‟ 9 1/4" from the face of the dartboard.
Locate a wall stud and place a mark 74-3/4 inches from the floor. This mark is for the top
screw hole. For the bottom two screws, you will measure down 15 inches from the top mark
you just made (59-3/4 inches from the floor).
Insert mounting screws in the center of the marks you made.
Mount the dartboard on the wall by lining up the holes on the back with the screws. It may be
necessary to adjust the screws until the board fits snugly against the wall.
Center of Bullseye should be 5' 8" from the floor when finished.
Top Screw
74-3/4"
All Rights Reserved
©2013 Escalade Sports

MOUNTING INSTRUCTION

Bottom
Screw
59-3/4"
4
D5360
5'8" from Floor to
Center of Bullseye
For Customer Service Call 1-800-526-0451
The following