Summary of Contents for Rocker BMX
- Page 2 ‘mini bmx’. However, Rocker is very different from other brands; it was designed by riders and will always be for riders. Rocker is designed based on many years experience in the BMX industry. It’s tough, VERY tough. The colourways have all been created by fans of Rocker BMX, making Rocker truly owned by the people who ride it.
- Page 3 You should have the main Rocker BMX To make life easier, we are going to first With the left pedal installed you can now Now, carefully remove the stem faceplate assembly, some bars with pre installed install the pedals. First off the left hand stand the bike up using the left pedal as bolts x 4 with a 6 mm allen key.
- Page 4 Once the faceplate starts to bite the bars, Check the front wheel alignment and If there is excessive play, remove it by On the first delivery of Rockers, the front spin the bars up into the correct position adjust as necessary (your stem rear pinch carefully tightening your headset pre wheel safety tabs are not installed, so at and finally clamp down the faceplate...
- Page 5 19mm spanner your new Rocker BMX. Now check your bottom bracket/crank Rocker BMX uses a USA BB as standard, assembly. Turn the cranks & look at the we also manufacture aftermarket 3 piece locking nut and cone to make sure they cranks and conversion BB’s with fully...
- Page 6 NOT be as or over tightness and allow the wheels to see that the rim comes into two pieces tight as it would be on a normal BMX with spin freely. away from the separate hub. You can a ‘driver’...
Need help?
Do you have a question about the BMX and is the answer not in the manual?
Questions and answers