Subscribe to Our Youtube Channel
Related Manuals for Mellerware ATLANTIC
Summary of Contents for Mellerware ATLANTIC
-
Page 1: Water Dispenser
ATLANTIC hot & cold water dispenser Hot water capacity: 5L/h at 85-95°C Cold water capacity : 0.75L/h at 13-15°C Removable drip tray Model: 30100 75 - 550 W _IM.indd 1 1/28/2014 1:45:12 PM... - Page 2 FUNCTION AND USE they do not play with the appliance. • The below instruction is mandatory for hand 1. Construction drawing mixers, blenders, choppers, etc, that have moving and interchangeable parts such as blades. • Switch off the appliance and disconnect from supply before changing accessories or approaching parts that move in use. • The machine should always be placed in a horizontal sturdy surface and the distance between the machine and the wall should be over 10cm. • Do not place or store the appliance where it can be pulled or fall into a tub of sink. • Do not reach for an appliance that has fallen into water. Unplug immediately. • Ensure that you use a non-poison plastic bottle. Warning: before you switch on the power, press the hot water faucet, make sure water flows out in order to avoid burning the elements. • When cleaning the appliance, disconnect from the power socket. Never immerse the appliance in water or pour water on it. Also avoid using gas or organic solvent. • Never operate this appliance if it is damaged or dropped into water. Return the appliance to a service centre for repairing. • Keep the cord away from heating surfaces. • The appliance should never be left unat- tended when plugged in or operating. • Use this appliance only for its intended use as described in this manual. • Do not replace the mains supply lead into the appliance – always use an authorized representative or qualified technician.
- Page 3 tal surface away from direct sunlight and (at the rear). sources of heat (stove, heater, radiator etc). • Now you are ready to use your Table Top Hot 3. T his table top water dispenser is not recom- and Cold Water dispenser. mended for outdoor use. 4. NB: The water dispenser is pre-cleaned at Instructions for cleaning: the factory but the reservoir and water lines • Unplug the dispenser from the power outlet. must be flushed with fresh water before us • The dispenser was disinfected before leav- as follows: ing the factory. You can use a fit for human • Keep the dispenser unplugged consumption disinfector to clean • Fill the water tank with tap water full to ca- it after six months. pacity. Wait for 5 minutes until water settles. • It is advisable to take it in for service after 1 • Proceed to drain the water from both faucets year in order to clean the heating pot. This until no more water is remaining. must be done by a qualified technician. • Proceed to make sure both drain caps and • Care is needed when cleaning the appli- faucets are closed. ance to ensure that water do not go into the • Place the water bottle on the water intake; electric power parts. allow water to stand approximately • Wash the inside of the reservoir with warm one minute. water and baking soda solution. The solution • Open water faucets to ensure water flows should be about 2 tablespoons of baking...
- Page 4 _IM.indd 4 1/28/2014 1:45:12 PM...
Need help?
Do you have a question about the ATLANTIC and is the answer not in the manual?
Questions and answers