Download Print this page

Whirlpool 30' Eye-Level Gas Range Installation Instructions page 5

Advertisement

C0nved~Q
IO 1 F! QoS should
be done
Use*0 wrench to
tin&re&
the dop from
the top &turnina
counter
clock&&
Turn Ge cap ober so the hole
Port No. 75566-01/706734
Rev E
01989
Whirlpool Corporation
I.+ : Lower Oven Burner: Remove
H oven racks at-id lower baneI
from oven bottom. Turn the o&e
hood
down until snug against pin. DO NOT
OVERTIGKTEN. The burner flame should
be Yz" long when air shutter is correctly
adjusted. The air shutterslides to close or
open the shutter OS needed
See Panel
C. Step 16. Replace
oven b3tom
and
Lower Oven
a Thermostat:
Remove
straight
OK
Use CI
Prepared
by Whlrlpml
Cotpxkn.
Bentm
Harbor.
Michigan
49022
Upper Oven Burner: Repeat
W SectionC.
Replace
oven
bottom and oven racks
F
?After
all the burners h&e been
W 5 co&e&d
ib L.P gas usage
and gas line is connected,
check for
leaks. Use a brush and liquid detergent
to test all gas connections
for leaks.
Bubbles around connections
will
indicate
a leak. If a leak appears,
shut
off gas valve controls and adjust
connections.
Then check connections
again. NEVER TEST.FOR GAS LEAKS WITH
A MATCH OR OTHER FIA.J,EI: -,'I
,*', li,.. d. 'I'_, ;t'-k;n.
Printed
,n U S A

Advertisement

loading