Manual Fine Adjustment Of White Balance; Digital Noise Reduction Function Setting [Dnr]; Black-And-White Mode Setting [D&N (Ir) ]; D&N (Ele) - Panasonic WV-CP620/G Series Operating Instructions Manual

Manual fine adjustment of white balance

The white balance is manually fine adjusted after white balance automatically adjustment in the automatic color temperature tracking
mode (ATW1, ATW2) or automatic white balance control mode (AWC).
Follow the procedures below.
"CAMERA SETUP" screen
**CAMERA SETUP**
SCENE1
ALC/ELC ALC
SHUTTER OFF
AGC ON(HIGH)
SENS UP OFF
WHITE BAL ATW1
DNR HIGH
D&N(IR) AUTO1
VMD OFF
RET TOP END
Step 1
Set "WHITE BAL" to "ATW1", "ATW2" or "AWC" and press the [SET] button.
→ The fine adjustment screen appears.
Step 2
Move the cursor to "R" and "B" and press the [LEFT] or [RIGHT] button to fine adjust the level for each. "R" stands for red and "B"
stands for blue.
When the level indicator moves in the "+" direction, the color becomes deeper, and when the level indicator moves in the "–"
direction, the color becomes lighter.
Step 3
Move the cursor to "AREA" and press the [SET] button to enter "AREA" setting screen.
The area to detect white area of white balance can be set on the area setting screen. The area to detect white area of white balance
is displayed full-screen by default.
Step 4
Move the cursor to "POSITION" and press the [SET] button.
Step 5
Press the [UP], [DOWN], [RIGHT] and [LEFT] buttons to move to the upper-left part of the area to be set, and press the [SET] button.
Step 6
Press the [UP], [DOWN], [RIGHT] and [LEFT] buttons to move to the lower-right part of the area to be set, and press the [SET] button.

7. Digital noise reduction function setting [DNR]

The digital noise reduction function reduces noise automatically under the condition of low illuminance.
The effect level of the noise reduction function is selectable from the following.
LOW: Low level of noise reduction (small residual image)
HIGH (default): High level of noise reduction (large residual image)
8. Black-and-white mode setting [D&N (IR) ]
The settings relating to the black-and-white mode can be configured.
Follow the procedure below
Fine adjustment screen
**ATW1**(1)
... I ...
R 0
- +
... I ...
B
0
- +
AREA
RET TOP END
CP620
[D&N (ELE) ]
CP600
Area setting screen
**ATW1 AREA**(1)
POSITION PUSH SET
RESET
RET TOP END
CF634
CF614
15