AT Continuous Ink Supply System Instruction

Continuous ink supply system; continuous supply;

AT Canon ip3000 CISS Instruction

Thank you for purchasing AT Continuous Ink Supply System. We appreciate your support and

will try our best to make your experience with our products a pleasant one. Printing has been a

different experience ever since you installed AT Continuous Ink Supply system on your own

printer. Just imagining being able to print without regard to the ink level in those expensive little

cartridges.

Please take your time installing AT Continuous Ink Supply system. Do not remove your old

cartridge until you have the AT CIS system primed and ready to install (to prevent the drying of

heads). In addition, make sure you are getting perfect nozzle checks before installing the AT

CIS system. The AT CIS system won't be able to work properly if the nozzles are previously

clogged.

Most people get a perfect nozzle check the first time after installing the AT Continuous Ink

Supply system; others may need to run two or three cleaning cycles or let the printer sit for a

while before they get the perfect results.

1. General Guide:

1) Components

A. CIS system

B. Air filters

C. Support Arm

D. Refill Kit

E. Instruction CD 1 pc

2) Opening box inspection

a、Check whether all the accessories are ready.

b、Check whether there's the leakage of the CISS, whether some tubes have been separated from the

CISS, whether there are air bubbles in the tube (If there exists more than 20CM air space, please kindly to

contact with the local dealer)

1 set

4 pcs

1 set

4pcs

Table of Contents

Do you have a question about the Continuous Ink Supply System and is the answer not in the manual?

Page 1 Please take your time installing AT Continuous Ink Supply system. Do not remove your old cartridge until you have the AT CIS system primed and ready to install (to prevent the drying of heads). In addition, make sure you are getting perfect nozzle checks before installing the AT CIS system.
Page 2 2. Installation Procedure: 1) 1 Step: Pull the rubber plug out of the bottom tray (Picture 9). Keep the Ink Filling Hole of the ink tank opened (Picture 10). Insert it into the bottom tray as following: 1) let Point 2 slide into the tray (Picture 11). 2) Tear the other side of the tray to let the Point 1 clip into the tray (Picture 12).
Page 3 After that: Put the CISS at the right side of Pull out the rubber plug from Insert the Air Filter. the printer. the Air Hole. 2) 2 Step: Remove the Original cartridge Open the cover and move the cartridge carriage to the below position, and then take off the Power Cord.
Page 4 Ink Tank. Carefully pull out the rubber plugs from the refill holes (there is possibility of ink splitting. Pls be careful!) Refill ink according to the colors. Then re-cap the rubber plug (Please keep the printer and the ink tank at the same horizontal level during the process of refilling ink.)
Page 5 2. Try to keep at least 1/2 inch of ink in the bottles, as you don’t want to run out of ink and draw air into the cartridge. 3. Don’t place the Reservoir Bottles higher or lower much than the printer.

Canon ip3000 ciss