Audio Ports - Biostar HI-FI-Z87X-3D Setup Manual

Start the Calibration:
Step 1:
Install and launch Multi Channels Calibration software
Step 2:
Arrange and connect the speakers in your room.
Step 3:
Select the channel output (2/ 4/ 5.1/ 7.1-channel) for the speak configuration.
Step 4:
Place the speaker setup microphone at ear height of a seated listener in your room
and connection it to Mic In jack.
Note: To setup 5.1-channel for a motherboard with 3 audio jacks, please connect the speaker
setup microphone to front panel Mic-In.
Step 5:
Select your preferred listening position and click the "Listening Position Button".
Step 6:
Click the "Calibration Button". You can see a notice window then click "Next" to start
the calibration. The test tone will be played through each speakers and it will take
2-3 minutes to process the calibration. Please make the room as quiet as possible at
the meantime.
Step 7:
After completing calibration, you will see a finish window then click "OK" to exit this
calibration.

Audio Ports:

For the definition of each audio port, please refer to the table below:
The 2/ 4/ 5.1-channel configuration for 3 audio jacks
Port 2-channel
Blue Line In
Green Line Out
Pink Mic In
The 2/ 4/ 5.1/ 7.1-channel configuration for 6 audio jacks
Port 2-channel
Blue Line In
Green Line Out
Pink Mic In
Orange --
Black N/A
Grey --
Note: Green, Orange, Black and Grey jacks are only for audio outputs.
4-channel 5.1 channel
Rear Speaker Out Rear Speaker Out
Front Speaker Out Front Speaker Out
Mic In Center/Subwoofer Out
4-channel 5.1 channel
Line In Line In
Front Speaker Out Front Speaker Out
Mic In Mic In
-- Center/Subwoofer Out
Rear Speaker Out Rear Speaker Out
-- --
Hi-Fi Z87X 3D
7.1 channel
Line In
Front Speaker Out
Mic In
Center/Subwoofer Out
Rear Speaker Out
Side Speaker Out
31