Advertisement
Tool specifications:
Rated Voltage: (V)
Rated Frequency: (Hz)
Rated current: (A)
No-load Speed: (RPM)
Speed Selection:
Right/Left Rotation:
Chuck Size:
Drilling Capacity (max):
- Steel:
- Wood:
Net Weight:
WARNING – To reduce the risk of injury, please read this instruction manual before use.
ATD-10538
3/8" Electric Drill
120
60
3.3
0-2700
Yes
Yes
3/8" (10 mm)
3/8" (10 mm)
3/4" (20 mm)
3 lbs (1.4kg)
Advertisement
Table of Contents
Related Manuals for ATD Tools ATD-10538
Summary of Contents for ATD Tools ATD-10538
- Page 1 ATD-10538 3/8” Electric Drill Tool specifications: Rated Voltage: (V) Rated Frequency: (Hz) Rated current: (A) No-load Speed: (RPM) 0-2700 Speed Selection: Right/Left Rotation: Chuck Size: 3/8” (10 mm) Drilling Capacity (max): - Steel: 3/8” (10 mm) - Wood: 3/4” (20 mm) Net Weight: 3 lbs (1.4kg)
-
Page 2: Intended Use
Intended use The ATD10538 drill is intended for impact drilling in brick, concrete as well as for drilling in wood, metal, ceramic and plastic. Electrical safety The electric motor has been designed for 120V only. Always check that the power supply corresponds to the voltage on the rating plate. - Page 3 2. Electrical safety. a) Power tool plugs must match the outlet. Never modify the plug in any way. Do not use any adapter plugs with earthed (grounded) power tools. Unmodified plugs and matching outlets will reduce risk of electric shock. b) Avoid body contact with grounded surfaces such as pipes, radiators, ranges and refrigerators.
- Page 4 4. Power tool use and care. a) Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it is designed. b) Do not use the power tool if the switch does not turn it on and off.
- Page 5 Description 1. Chuck 3. Ventilation slots 7. Forward / Reverse switch 8. Speed selector thumbwheel 9. Switch 10. Lock button Applications (Use only for the purposes listed below.) ·Drilling wood,materials and resin boards. ·Drilling metal steel brass, aluminum sheets, stainless steel & pipe. Noise build-up Noise (sound pressure level) in the workplace can exceed 85 dB.
- Page 6 Initial Operating Always use the correct supply voltage: The power supply voltage must match the information quoted on the tool identification plate. Switch (Fig.1) This tool is started and stopped by pressing and releasing the switch (9). The speed can be adjusted in the high gear or in the low gear, by controlling the on/off-pressing force.
-
Page 7: Maintenance
Mounting and removing the bit (Fig.3) Insert the bit (16) into the keyless chuck (1) as far as it will go. While holding stationary base of chuck, with one hand, tighten the moveable portion of the keyless chuck with your other hand until bit is firmly held in place. Be sure that that the bit does not move and is held by all three jaws as you tighten the chuck. -
Page 8: Wear Respiratory Protection
The brushes should be checked periodically and worn-out brushes should be replaced in time. After replacing, inspect whether the new brushes can move freely in the brush holder. Keep running the motor for 15 minutes to match the contact of the brushes and commutator.
Need help?
Do you have a question about the ATD-10538 and is the answer not in the manual?
Questions and answers