Components; Operation; Cutters - DeWalt DWP611 Instruction Manual

WARNING: To reduce the risk of injury, turn unit off
and disconnect it from power source before installing and
removing accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.
Components (Fig. 1–11)
WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result
A. Quick release tabs
B. Depth adjustment ring
C. Variable speed dial (DWP611 only)
D. On(l)/off (o) switch
E. Spindle lock button
F. Led lights (DWP611 only)
G. Guide pin groove
H. Micro adjustment scale
I. Locking lever
J. Edge guide slot (fixed base)
K. Subbase
(DWP610 has a round subbase, DWP611 has a D-subbase)
both are available as an accessory.
L. Vacuum attachment (For use with plunge base)
M. Holes for premium edge guide (sold separately)
N. Turret stop
O. Depth adjustment rod
P. Plunge lock lever
Q. Edge guide
R. Guide pins
S. Locking lever adjustment screw
T. Centering tool
U. Collet nut
V. Vacuum attachment (fixed base)
W. Screws (vacuum attachment)
X. Edge guide slot (plunge base)
Z. Motor unit
AA. Motor stop
BB. Thumb screw
CC. Knurled knob
DD. Depth adjustment scale
EE. Zero adjuster tab
FF. Sub-base screws
GG. Edge guide screws
HH. Tab (vacuum attachment)
II. Snap tab (vacuum attachment)
JJ. Plastic washer (vacuum attachment)
KK. Thumb screw (vacuum attachment)

OPERATION

WARNING: To reduce the risk of injury, turn unit off and
disconnect it from power source before installing and removing
accessories, before adjusting or when making repairs. An
accidental start-up can cause injury.
NOTICE: Do not use router bits with a diameter in excess of
1-3/8" (34.9 mm) in this tool.

Cutters

The tooling can be used with the complete range of commercial
cutters (e.g: straight, rebate, profile cutter, slotter cutter or grooved
knife) with the following technical data:
1. Shank diameter 6–8 mm
2. Cutter speed of min. 30 000/min
37