Electrical Work - Toshiba RAS-B10SKVP-E Installation Manual

01_Installation_EN.fm Page 7 Tuesday, December 26, 2006 4:36 PM
Mounting the installation plate
When the installation plate is directly mounted on the wall
1. Securely fit the installation plate onto the wall by screws with the upper and lower catches.
2. To mount the installation plate on a concrete wall use anchor bolts. Drill the anchor bolt holes as illustrated in the above figure.
3. Place the level at the top end of the installation plate, and check that the plate is horizontal.
CAUTION
When installing the installation plate with mounting screws, do not use anchor bolt holes. Otherwise the unit may fall down and
result in personal injury and property damage.
CAUTION
Failure to securely install the unit may result in personal injury and/or property damage if the unit falls.
• In case of block, brick, concrete or similar type walls, drill 5 mm dia. holes in the wall.
• Insert clip anchors for the
f
NOTE
• Install the installation plate using between 4 to 6 mounting screws, making sure all four corners are secure.

Electrical Work

1. The supply voltage must be the same as the rated voltage of the air conditioner.
2. Prepare a power source for the exclusive use of the air conditioner.
NOTE
• Wire type: H07RN-F or 60245IEC66 (1.0 mm
Anchor bolt holes
Pipe hole
Indoor unit
5 mm dia. hole
f Mounting screw
Clip anchor
(local parts)
mounting screws.
2
)
a Installation plate
Pipe hole
f Mounting screw
Anchor bolt
Projection 15 mm or less
I4 x 25L
7 EN