Advertisement
3.
Check the volume control of the subwoofer.
4.
Refer to your amplifier/receiver manual to make sure you have adjusted its bass output properly.
MUDDY OR BOOMY BASS
1.
Check the volume control for the subwoofer. Excess volume can cause speakers to sound distorted and unnatural.
2.
Try adjusting the crossover control on the subwoofer or the subwoofer setup on your receiver to a slightly lower frequency (example:
reduce from 120 Hz to 80 or 60 Hz).
3.
If the subwoofer or full size speaker is close to a corner, side or back wall, try moving it away from the wall. This may reduce the
"boomy" bass considerably.
4.
Bookshelf speakers placed in a semi-enclosed space or cabinet can artificially emphasize bass output. Reduce the bass control on
your amplifier or move the speakers to the front of the cabinet. Alternatively, reposition the speakers to a more open location.
DISTORTED SOUND FROM THE SPEAKERS
1.
This problem is usually caused by setting the volume control too high. Reduce the amplifier/receiver volume to a lower level.
2.
If noise and distortion are audible at higher volume levels, your amplifier may not be powerful enough. Consider upgrading to a unit
with higher power.
NOTE: Remember, even though your Phase Technology speakers can handle considerable power levels, ANY speaker if used improperly can
be damaged. Consult your Phase Technology dealer for assistance in choosing a new amplifier or receiver.
[WARRANTY]
LIMITED WARRANTY: Phase Technology warrants its loudspeakers to be free from defects in material and workmanship for a period
of ten (10) years for speaker product, limited lifetime for CI speakers, and three (3) years for the electronic components to the original
purchaser. Purchase must be made from an authorized Phase Technology dealer.
This warranty does not cover service or parts to repair damage caused by misuse, abuse, damage while in transit, alterations,
unauthorized repairs, failure to follow instructions, fire, flood or any other cause beyond the reasonable control of Phase Technology.
Defects in speaker cabinets or grilles must be brought to the attention of your dealer immediately after purchase. This warranty will be
void if the products' serial number has been altered or removed.
Should your Phase Technology product require service, please call the MSE Audio customer service department for a return authorization.
All merchandise returned to Phase Technology without prior authorization will be refused. For your return authorization number, please
call 855.663.5600 or email sales@mseaudio.com.
[SPECIFICATIONS]
8" Mineral-filled Poly Cone w/ NBR Surround
WOOFER
100 W Continuous, 200 W Peak
AMP POWER
36 Hz - 200 Hz
FREQ RESPONSE
50 Hz - 200 Hz Variable
LOW PASS CROSSOVER
YES
AUTO ON/OFF
2x Push-Terminals Pairs
SPEAKER LEVEL INPUTS
2x Push-Terminals Pairs
SPEAKER LEVEL OUTPUTS
.25" Jack
LINE LEVEL INPUTS
Bass-Relfex
ENCLOSURE TYPE
10.75" H x 14" W x 16" D
DIMENSIONS
25.78 lbs.
WEIGHT
Black Ash
FINISH OPTIONS
HV81
10" Mineral-filled Poly Cone w/ NBR Surround
100 W Continuous, 200 W Peak
29 Hz - 200 Hz
50 Hz - 200 Hz Variable
YES
2x Push-Terminals Pairs
2x Push-Terminals Pairs
.25" Jack
Bass-Relfex
16.125" H x 13.75" W x 16.75" D
36.16 lbs.
Black Ash
Copyright © 2014 MS Electronics, LLC. All rights reserved. MSE Audio, Phase Technology and PhaseTech are registered trademarks and
"Speakers for your Life" is a trademark of MSE Audio, Overland Park, Kansas USA. Phase Technology is part of MSE Audio
HV101
6
HV121
12" Mineral-filled Poly Cone w/ NBR Surround
100 W Continuous, 200 W Peak
25 Hz - 200 Hz
50 Hz - 200 Hz Variable
YES
2x Push-Terminals Pairs
2x Push-Terminals Pairs
.25" Jack
Bass-Relfex
17.25" H x 15.75" W x 18.25" D
40.22 lbs.
Black Ash
®
. www.phasetech.com.
Advertisement
