Step 3: Power Up The Appliance; Step 4: Connect The Appliance To The Network - 3Com AirProtect Enterprise Engine 6100 Quick Setup Manual

Step 3: Power up the Appliance
Connect the power cable as shown in the figure below and press the power switch on the front
panel of the appliance.
Important! On connecting the Power cable, the Power LED should turn solid green. If this does not happen,
refer to the 3Com AirProtect Enterprise Installation Guide.
Step 4: Connect the Appliance to the Network
Connect the appliance to the network using the network interface cable as shown in the figure
below.
Warning! The default IP address of the appliance is 192.168.1.246. Please ensure that no other device on
your network uses the same IP address as the appliance. Connect the network interface port on the appliance
to the desired subnet using the network interface cable provided to you. Do not connect the High
Availability (HA) Interface port to the subnet.
110-240V 50/60
Hz AC Connection
3Com AirProtect Enterprise Quick Setup Guide
3