Adding Fabric Softener; Water Supply Connector Filter; Cleaning The Filter - Samsung WA90F5S4 User Manual

ADDING FABRIC SOFTENER

1. When the proper amount (one time dose) of fabric softener is stored in the softener inlet, it is
automatically added during the last rinse cycle.
2. Do not add detergent, bleach or starch into the softener inlet.
3. Using too much softener may produce unsatisfactory results.
4. Do not open the lid during the Spin cycle. If added too early, its effectiveness will decrease.
5. Do not leave the softener in the softener dispenser for a long time as it may congeal.
If the water pressure is low, the fabric softener may remain in the softener compartment. In
this case, put the fabric softener into the tub directly.

WATER SUPPLY CONNECTOR FILTER

1. Pull out the fi lter and wash well.
2. Pull in the fi lter and connect the hose to the inlet water valve
tightly.
3. Check if there is a leakage.
Note to tighten up the connector.

CLEANING THE FILTER

Clean the filter net often to keep the washer clean.
1. Push the upper part of the Hygiene fi lter
and pull in.
3. Clean the Hygiene fi lter.
F500S_W3050_WA11F5-03272M_EN.indd Sec5:21
2. Open the cover as shown in the fi gure.
4. Close the cover and insert the lower part of
the fi lter in the basket fi rst and then push
the fi lter with "click" sound.
installation & maintenance_21
2013-04-26 3:52:01