Table of Contents
Advertisement
USING THE MACHINE
• Choosing the cutting device
Choose the most suitable cutting device for the job to
be done, according to these general indications:
– the 3-point blade is suitable for cutting brush-
wood and small shrubs up to 2 cm in diameter;
– the cutting line head can eliminate tall grass and
non-woody vegetation near fences, walls, founda-
tions, pavements, around trees, etc. or to com-
pletely clean a particular area of the garden;
WORKING TECHNIQUES
a) 3-point blade (Fig. 11)
Start cutting above the undergrowth and then move
down with the scything blade so as to cut the brush
into small pieces.
b) Cutting line head
WARNING!
use of metal lines, plasticised metal lines and/or
lines not suitable for the head can cause serious
injuries and wounds.
During use it is advisable to stop the engine periodi-
cally and remove the weeds wound round the ma-
chine, so as to prevent the drive tube from overheat-
ing due to the grass caught under the guard.
Remove the caught-up grass with a screwdriver to al-
low the rod to be properly cooled.
WARNING!
sweeping, tilting the cutting line head. The power
of the engine could throw objects and small
stones 15 metres or more, causing damage and
injuries to people.
• Cutting in motion (Scything) (Fig. 13)
Proceed at a regular pace, with a circular motion sim-
ilar to a traditional scythe, without tilting the cutting line
head during the operation.
First try cutting at the right height in a small area, so
as to then achieve a uniform cutting height keeping
the cutting line head at a constant distance from the
ground.
For heavier cutting it can be useful to tilt the cutting line
head by about 30°.
Use ONLY nylon lines. The
Do not use the machine for
WARNING!
there is the possibility of causing objects to be
thrown, which could harm people and animals
and cause damage.
• Precision cutting (Trimming)
Keep the machine slightly tilted so that the lower part
of the cutting line head does not touch the ground and
the cutting line is at the required point, always keep-
ing the cutting device at a distance from the operator.
• Cutting near fences/foundations (Fig. 14)
Slowly approach the cutting line head to fences,
posts, rocks, walls, etc. without hitting them hard.
If the line strikes a solid object it could break or be-
come worn; if it gets tangled in a fence it could break
abruptly.
In any case, cutting around pavements, foundations,
walls, etc. can cause greater wear than normal in the
line.
• Cutting round trees (Fig. 15)
Walk round the tree from left to right, approaching the
trunks slowly so as not to strike the tree with the line
and keeping the cutting line head tilted forward
slightly.
Remember that the nylon line could lop or damage
small shrubs and that the impact of the nylon line
against the trunk of bushes or trees with soft bark
could seriously damage the plant.
• Adjusting line length when working (Fig. 16)
This machine is fitted with a "Tap & Go" head.
To release more line, tap the cutting line head against
the round with the engine at top speed: the line will be
released automatically and the knife cut off the excess
length.
END OF OPERATIONS
When you have finished your work:
– Switch off the engine as indicated above (Chap. 6).
– Wait for the cutting device to stop and fit the blade
guard.
EN
Do not work in this way if
11
Hide quick links:
Advertisement
Table of Contents
