Thank you for purchasing our company products. Please read these instructions carefully to enjoy optimum performance and a longer service life before you start to use. CONTENTS pCONTENTS ............................2 Unpacking Inspections ..........................3 Unpacking instructions ........................3 ...
UNPACKING INSPECTIONS Unpacking instructions Please unpack the carton and check the goods carefully when you receive it , if discover packing damage, shortage or quality problem, please notify the shipper and reject the goods. Before using this product, please read the instructions carefully and keep it in a safe place for future reference.
Operation Instructions Power supply connecting Two sockets in the product, Power In and Power Out , the product can be supplied power by the power out. Maximum output power of the socket is 480W . POWER IN POWER OUT Maximum connecting machines are 8 units with the same model Control panel operation Use the four buttons MODE...
Act mode Standalone) Set the product in one of the standalone modes to control without connecting a DMX controller. Note: Never connect a product that is operating in any standalone mode to a DMX string connected to a DMX controller. Follow below actions to setup standalone mode Press <MODE>...
IR control It is fully compatible with the IRC (Infrared Remote Control),please follow below to setup. Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display. Use <UP> or <DOWN> to select S-1r, Press <ENTER>, Begin using the IRC The functions of IRC: Automatic Mode Automatic Mode will enable you to run the automatic programs on the...
DMX Mode Auto Sync It offers wireless control of two or more products with a single DMX controller. To set syncing function for DMX functionality automatically, do the following: For the transmitting product. Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display. Use <UP>...
For the receiving product(s). Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display. Use <UP> or <DOWN> to select SYS. Press <ENTER>. Press <UP> or <DOWN> until S-tr appears on the display. Press <ENTER>. Press <UP> or <DOWN> until dR.CH appears on the display. Press <ENTER>.
Master/slave mode Standalone master/slave The Master/Slave Runway Effect enables one product (the “master”) to control the actions of one or more other products (the “slaves”) in sequential order for a “runway” effect without the need of a DMX controller. The master product will be set to operate in specific automatic modes, while the slave products will be set to operate in slave mode.
Multi-groups connecting with DMX Wonderful colors and beautiful lighting effect can be displayed by multi-groups of products controlled by DMX512, DMX512 signal is received and transmitted by the the first product for each groups. No.3 No.2 No. .. No.1 No.3 No.
MAINTENANCE The unit should be cleaned periodically to ensure the optimum performance, the smudginess can decrease the life of light and the output of light is affected by the dust which can make the machine overheating. In general, make the maintenance at least two times a month. Be sure to power off the unit before cleaning .
Bedrijvenpark Twente 415 7602 KM - ALMELO Tel : 0031546589299 Fax : 0031546589298 The Netherlands Product number: 150.569 Wi-Par 8x 3W LED Tri Color Battery 2.4GHz DMX Product Description: Beamz, Regulatory Requirement: EN 60598-1/-2-17:2009 EN 62031:2008 EN 61347-2-13:2007 EN 300440-1/-2:2010 EN 62479:2010...