1. Manuals
  2. Brands
  3. Dynamix Manuals
  4. Telephone Accessories
  5. hp-52m
  6. Quick start manual

Dynamix hp-52m Quick Start Manual

Hide thumbs
1
2
3
4
5
6
7
8
9
Table of Contents

Advertisement

Quick Links

Download this manual
Coax MDU
Master Bridge
Q
u
i
c
k
S
t
a
r
t
G
u
i
d
e
Q
u
i
c
k
S
t
a
r
t
G
u
i
d
e
Version 1.0
Jan. 2010

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the hp-52m and is the answer not in the manual?

Questions and answers

Summary of Contents for Dynamix hp-52m

  • Page 1 Coax MDU Master Bridge Version 1.0 Jan. 2010...

  • Page 2: Packing List

    4. Link/Act: Lighting up when HCNA port is active, and flashing when there is any data traffic. 5. Quality: Dual led. Shows in Green/Orange/Red for respected High/Medium/Low average HCNA speed. 6. Diagnosis: Lighting up when HP-52M is diagnosing HCNA connection toward/from EP. - 1 -...

  • Page 3: Rear Panel

    3. LAN1/LAN2: Two Gigabit Ethernet ports to connect uplink Switch/FTTx/PON/xDSL Modem. 4. Reset: While HP-52M is on, press and release this button will reboot HP-52M. Press it for lasting 5 seconds will restore all settings to factory default. For example, the IP address will restore to default ‘192.168.1.1’.

  • Page 4: Side Switch

    Side Switch Rocker Switch 1. DC IN: Runs in Local Power mode, powering HP-52M via DC adapter plug. 2. LINE: Runs in Line Power mode, powering HP- 52M via the coax cable connected to port ‘HCNA’. (Port ‘HCNA’ holds both data and power).

  • Page 5: Configure By Web Browser

    ‘255.255.255.0’. To access the bridge with default IP, your PC should be within the same IPv4 network as the bridge HP-52M. That is, your PC's IP address should be as "192.168.1.xxx". For instance, you may connect your PC with the bridge directly by one Ethernet cable between your PC's Ethernet adapter and bridge's port LAN1.
  • Page 6 mask as "255.255.255.0", disable DHCP option. Make your PC and the bridge within the same "192.168.1.xxx" network. Type in 192.168.1.1 your browser’s website navigating field, as the following, The bridge will prompt you a window for authorization. The factory default Username is ‘admin’, also Password is ‘admin’.

  • Page 7: Troubleshooting

    displays the contents for the selected item. Click your mouse on the item in the left window will pop out the corresponding item-window in the right side. Click on the ‘Apply’ button (or ‘OK’ button) will submit your new settings into the bridge and will take effect immediately.
  • Page 8 § Check the configuration settings in the bridge, Bridge and EP have the same “Privacy Key”. “Host Limit” for each EP is not zero. “HPNA” port for each EP is not disabled. For unmatched “Privacy Key”, it is not possible to send/receive data between the bridge and each EP.
  • Page 9 Can not reach high speed communication: § Please check the settings of bandwidth control, or the maximal throughput of your WAN service. § Please check your physical connection quality. § Consult with your service provider for potential specific-application-optimized Firmware. - 8 -...

Table of Contents