Pioneer Asterix ST-EP4 Installation Manual

Pioneer Asterix ST-EP4 Installation Manual

Connecting the asterix st-ep4 printer to an altametrics e*smart all-in-one station

Advertisement

Printer Installation Guide
Asterix ST-EP4 Printer Installation Guide
This guide will walk you through connecting the Asterix ST-EP4 printer to an Altametrics
e*Smart All-in-One Station.
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Asterix ST-EP4 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Pioneer Asterix ST-EP4

  • Page 1 Printer Installation Guide Asterix ST-EP4 Printer Installation Guide This guide will walk you through connecting the Asterix ST-EP4 printer to an Altametrics e*Smart All-in-One Station.
  • Page 2 COM1 on the computer. It is also possible however to connect an Asterix ST-EP4 thermal remote printer to an S-Line Series terminal to work with Hula POS by following the steps outlined below.
  • Page 3 Printer Installation Guide 2. Connect the power supply to the designated 24V power port, also located on the back of the printer. 3. Connect the included RJ-45 Ethernet printer cable to the 25-pin DB connector that we connected in Step 1.
  • Page 4 Printer Installation Guide 4. Connect the other end of the RJ-45 Ethernet cable to the desired COM port on the computer. In our example below, we are connecting our printer to COM2. Note: It is a good idea to note down which COM port the printer has been connected for future reference as you will need this information when configuring the printer(s) in the Hula software.

Table of Contents