Advertisement
Quick Links
OPERATING AND MAINTENANCE INSTRUCTIONS
For your safety:
If you smell gas:
1. Shut off gas to the appliance
2. Extinguish any open flame
near unit.
3. If odor continues, immediately
call your gas supplier
This manual should remain with the homeowner or parties responsible for operation.
(Rev D)
Fire-Water Bowls
Model 100
OWNER'S MANUAL /
For your safety:
Do not store or use any gasoline or
other flammable vapors and / or
liquids in the vicinity of this or any
other appliance.
Advertisement
Summary of Contents for fire's edge 100
- Page 1 Fire-Water Bowls Model 100 OWNER’S MANUAL / OPERATING AND MAINTENANCE INSTRUCTIONS For your safety: For your safety: If you smell gas: Do not store or use any gasoline or 1. Shut off gas to the appliance other flammable vapors and / or 2.
-
Page 2: Table Of Contents
Table of Contents Gas and Electrical Requirements Page 3 Installation Page 3 Burner Setup and Adjustment Page 8 Maintenance Page 9 Operation Page 10 Control Panel Wiring Diagram Page 12 Burner Assembly Wiring Diagram Page 13... -
Page 3: Gas And Electrical Requirements
Low voltage wiring (14 or 16 ga. 24Vac) shall be installed underground between the Control Panel and each Bowl. Wire per Fire's Edge wiring diagram. 120 v source into Control Panel can come from any 120v source, including pool controller or home system. - Page 4 Note: The gas and electrical and water connection at each Bowl must be located at the center of each Bowl. The connections must be installed as shown in Figure 4. Fig. 1 (Natural Gas) Fig. 2 (Propane Gas)
- Page 5 Fig. 3 (Commercial Installation) Fig. 4...
- Page 6 Important: The Mounting Bracket must be installed for proper cooling of Burner Assembly. Warranty is voided if bracket is not installed. Note: Do not caulk or seal around the base of the Bowl. (See Fig. 10) Fig. 5 Optional Drain Orientation-Prevents Dirty Water From Draining Out on Wall Fig.6...
- Page 7 Optional Mounting Method With Out Mounting Bracket Fig. 7 Fig. 8...
-
Page 8: Burner Setup And Adjustment
If this happens, carefully purge the air from the gas line. Caution: When purging air from a propane system, disconnect wires going to Burner Assemblies (terminals X1/X2) located in Fire's Edge Control. There should be no power at Burner Assemblies when purging Propane. -
Page 9: Maintenance
Burner Adjustment Note: Each Burner should have a flame height of approximately 12” – 15” from the top of the Bowl. 3.70 The height of the flame can be adjusted at each Burner by opening or closing the ½” Gas Valve or Keyed Valve as shown in Fig. 4. 3.75 Each Burner should be adjusted as required so that the flame size at each Bowl is similar in appearance to each other. -
Page 10: Operation
The System needs to be turned on/off after a rain to remove any water in the pilot area. Note: If any problems are present, consult a licensed heating Specialist or call Fire's Edge. Fig. 10 Operation Warning: This unit is for outdoor use only For your safety: If you smell gas, shut off Gas Valve immediately. - Page 11 If you experience problems with this unit, call a licensed heating professional. All work on this unit shall be performed by a licensed heating professional. Caution! Before you turn on the Fire's Edge System, make sure that features are clear of people, animals or any objects that are combustible.
- Page 14 Fire's Edge 1 year Limited Residential Warranty-6 Months Commercial Fire's Edge will replace, at its expense, any unit, which in normal use, has proven to be defective in workmanship or material, provided that the customer returns the product prepaid to Fire's Edge with proof of product within one year and provides Fire's Edge with reasonable opportunity to verify the alleged defect by inspection.