Machine-Specific Safety Warnings; Functional Description - Bosch GSR 6-25 TE PROFESSIONAL Operating Instructions Manual

OBJ_BUCH-137-001.book Page 2 Monday, April 24, 2006 9:59 AM
f) Keep cutting tools sharp and clean. Prop-
erly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.
g) Use the power tool, accessories and tool
bits etc. in accordance with these instruc-
tions, taking into account the working con-
ditions and the work to be performed. Use
of the power tool for operations different from
those intended could result in a hazardous situ-
ation.
5) Service
a) Have your power tool serviced by a quali-
fied repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
Machine-specific
Safety Warnings
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
Never use the machine with a damaged cable.
Do not touch the damaged cable and pull the
mains plug when the cable is damaged while
working. Damaged cables increase the risk of an
electric shock.
Connect machines that are used in the open
via a residual current device (RCD).
Always wait until the machine has come to a
complete stop before placing it down. The tool
insert can jam and lead to loss of control over the
power tool.
Hold the machine with a firm grip. High reaction
torque can briefly occur while driving in and loosen-
ing screws.

Functional Description

Read all safety warnings and all
instructions. Failure to follow the warn-
ings and instructions may result in electric
shock, fire and/or serious injury.
While reading the operating instructions, unfold the
graphics page for the machine and leave it open.
Intended Use
The machine is intended for driving in and loosening
screws.
2 609 932 513 • 24.4.06
Product Features
The numbering of the product features refers to the
illustration of the machine on the graphics page.
1 Screwdriver bit*
2 Stop bushing
3 Adjustment sleeve for screwing-depth stop
4 Screwing-depth stop
5 Belt clip
6 Lock-on button for On/Off switch
7 On/Off switch
8 Rotational direction switch
9 Universal bit holder*
*The accessories illustrated or described are not
included as standard delivery.
Noise/Vibration Information
Measured values determined according to EN 60745.
Typically the A-weighted noise level of the machine is:
sound pressure level 85 dB(A); sound power level
96 dB(A). Uncertainty K=3 dB.
Wear hearing protection!
The typical hand/arm vibration is below 2.5 m/s
The vibration emission level given in
WARNING
this information sheet has been meas-
ured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with
another.
The vibration emission level will vary because of the
ways in which a power tool can be used and may
increase above the level given in this information sheet.
This could lead to a significant underestimate of expo-
sure when the tool is used regularly in such a way.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given period
of work should also take into account the times when
the tool is switched off and when it is running but not
actually doing the job. This may significantly reduce the
exposure level over the total working period.
Declaration of Conformity
We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents: EN 60745 according to
the provisions of
98/37/EC.
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
English–2
2
.
the directives 89/336/EEC,
Dr. Eckerhard Strötgen
Head of Product
Certification