Sabio DM1U Quick Start Manual

Quick
Start
Guide
2.5" Hard Drive Enclosure
Models and features
DM1U
2.5" HDD USB 2.0 enclosure kit
USB mini-B port
Case screws
DM1F
2.5" HDD USB 2.0/FireWire 400/FireWire 800 enclosure kit
USB mini-B FireWire 800 FireWire 400
port Port Port
Case screws
Package contents
DM1U
Soft case
-OR-
DM1F
USB Type A to IEEE 1394a
mini-B cable (FireWire) cable
(DM1F only)
1
2
3
4
5
Quick Start Guide
Screws
6
IEEE 1394b
(FireWire) cable
(DM1F only)
Assembling the
enclosure
Press the lid down while sliding it away
from the end with the USB port. The
enclosure contains a circuit board and a
package of four screws.
Carefully remove the circuit board from the
enclosure, then insert your 2.5" hard drive's
SATA and power connectors into the SATA
and power slots on the circuit board. Make
sure that the connectors are fully inserted.
Turn the hard drive assembly over, then
secure the circuit board to the hard drive
using the two large screws in the package.
Make sure that the circuit board and hard
drive remain aligned while you tighten the
screws.
Carefully slide the assembly into the
enclosure so that the port(s) on the circuit
board slide into the port opening(s) on the
enclosure, and the two posts in the
opposite end of the enclosure align with
the two holes at the bottom of the drive.
Place the lid on top of the enclosure,
making sure that the two copper screw
Contact Us
holes in the enclosure are aligned with the
screw holes on the circuit board, then
press the lid down while sliding it toward
the end with the USB port. Make sure that
the lid is flush with the enclosure case.
Secure the lid to the case using the two
small screws in the package.
Turn on the computer, then connect the USB 2.0 or IEEE 1394
1
(FireWire) cable to the corresponding port in the enclosure.
Note: FireWire cables can only be connected to the DM1F
enclosure.
Caution: The enclosure should be connected to the computer
using only one type of cable. Connecting more than one cable
may cause data errors and damage the enclosure's circuit board
and hard drive.
Connect the USB 2.0 or IEEE 1394 (FireWire) cable to an
2
available port on the computer. The enclosure is automatically
detected by the computer, and the enclosure's LED activity
indicator shines steadily blue. The same LED flashes while the
drive is being accessed.
LED
402-494-6013
Important: Contact Sabio before returning product to the retailer.
support@sabioproducts.com
www.sabioproducts.com
Connecting to a
computer