Product Features - VTech Switch & go dinos turbo User Manual

PRODUCT FEATURES

1. TURN THE UNIT ON
Slide the Remote Control Off/Channel Switch to the
I or II position to turn the Remote Control ON.
Slide the Off/Channel Switch on Bronco the RC
Triceratops™ to the same I or II position as the
Remote Control. The Remote Control and Bronco
the RC Triceratops™ must be on the same I or II
channel to send and receive signals.
Note: I and II settings are two different channels the Remote Control
and Bronco the RC Triceratops™ can operate on. If two units
are operating in the same vicinity, put one unit on channel I
and the other on channel II.
2. REMOTE CONTROL POWER INDICATOR
After the Remote Control is turned ON, the
Remote Control Power Indicator will flash to
show the remote is ON. The indicator light will
illuminate anytime a button is pressed, lever is
pulled or the Steering Wheel is turned. The light
indicates a signal is being sent to Bronco the
RC Triceratops™.
3. TRANSFORMATION BUTTON
Press the Transformation Button to remotely
transform Bronco the RC Triceratops™ from
dino to vehicle or from vehicle to dino.
6