Manufactures Identification Code (MIC) Coastal Inflatable Boats confirm with the Federal requirement that every boat must have its own unique Hull Identification Number (HIN), which the first three characters must contain the company's Manufactures Identification Code (MIC).
& floor until the hand pump becomes somewhat difficult to push down. 3. Due to the boat having a safe valve to prevent over-pressure installed, a boat inflated for 4 to 5 days may lose pressure and require re-inflation to correct operating pressure, this is normal. It doesn't mean that your boat has a leak, it means the safety over-pressure valve is protecting your boat! 4.
ASSEMBLY FOR BOATS WITH INFLATABLE DECK Find flat surface where boat will be assembled. 2. Remove any sharp objects from the area where boat will be assembled and inflated. 3. Unfold and spread boat out flat. 4. Connect the pump to the valve by inserting the adapter attached to the pump hose into the valve, turning it until it tightens.
ASSEMBLY FOR BOATS WITH ALUMINUM DECK Assemble the deck floor outside the boat first to get the concept of how the floor is assembled. At the same time install the rubber grommet into the opening in the rear panel. See the images below:...
Page 7
12. Since the boat is a bit wider towards the back, it may make it easier to fit the first stringer (the larger one) near the rear but away from the transom. We usually install it where the #4 & #3 board join together.
We recommend that you cover your boat when it will not be in use for extended periods of time. While we realize that it is not practical to cover your boat every time you get out of it, if the boat is not going to be used for several days it is advisable to cover it.
If you see bubbles forming, check your valve fitting and base and be sure the valve insert is screwed on tight and pushpin is in correct position. If the leak is not in the valve, then spray the rest of the boat to find the leak.
Make sure there is no water in the boat. Excess water in the boat can quickly lead to failure of the towing rings, especially when the load is not being equalized. Even just six inches of water in an inflatable can weight hundreds of pounds to the boat.
The operator must have an unobstructed view particularly to the front. Never operate your boat directly behind a water skier in case the skier loses control and hits the water. Use extreme caution around any swimmer, diver or persons in the water.
We warranty each new Coastal Inflatable Boat and accessories attached, thereto (hereafter referred to as "Product"), to be free from defects in material and workmanship. This warranty shall become effective on the purchase date of the boat. Transfer of warranties is not authorized without approval of Coastal Inflatables, LLC This warranty is as follows: A five (5) year guarantee on the seams &...
Coastal Inflatable LLC, its directors, officers, representatives, agents, and employees from any and all liability for injury of any kind to buyer or to boat or other property buyer may have, incurred by reason of any act or failure to act, on buyer part, or Coastal Inflatables, LLC, its directors, officers, representatives, agents, and employees, arising because of the use of above mentioned inflatable boat.
Need help?
Do you have a question about the Boat and is the answer not in the manual?
Questions and answers