• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult Cardio Theater or an experienced radio/TV technician for help. WARNING : To Prevent Fire Or Electrical Shock, Do Not Expose These Appliances To Rain, Moisture, or...
LCD Screen Assembly 1. Remove back metal cover plate to expose the monitor connections. (Figure 1) Disconnect the connector that is attached to the RJ45 telephone connector board that is mounted on the back cover plate. (Figure 2) 2. Place monitor onto assembled stand and secure with three M4 x 10 mm screws provided.
Page 5
LCD Screen Assembly (continued) Remove slip on connector from monitor connection labeled “ANT” by pulling straight down as shown in Figure 5. Screw on antenna cable coming from stand harness onto the slip on connector just removed. Push slip on connection with antenna cable attached back into monitor “ANT”...
Mounting Screen Controller Remove backing from neoprene mounting pad and place either vertically or horizontally around equipment handrail as appropriate as shown below. Insert two nylon wire ties (provided) through the bottom holes in the mounting bracket on the rear of the Screen Controller. Attach wire ties as tightly as possible around the horizontal or vertical bar so the controller can’t be rotated.
Auto Programming TV Channels The following requires the LCD Screen Master IR Remote. 1. Press “Menu” button on Master IR remote 2. Scroll down to “Install” using the Channel down button, press the “Select” button when “install” is highlighted. 3. Highlight “Auto Search” by using the channel down button, then press “Select” 4.
Controller Features • Description of Features There are three programmable features on the Cardio Theater Controller. • Auto power on/off feature If this feature is turned on, unit will power down automatically 15 seconds after Headphones are removed from the controller. Unit will automatically power on as soon as headphones are detected in headphone jack.
Smart Controller Programming Programming mode is entered into by pressing and holding down both the Volume Up and the Volume Down buttons on the controller at the same time, until the power LED begins blinking, then let go of buttons (LED will continue to blink as long as you are in programming mode). Once in programming mode you have 15 seconds to begin to adjust one of the features, before it times out and automatically goes back into normal operating mode.
RF Distribution Below is a diagram of a typical install. Please note that the tap values are dependant on having a 35 db signal at the output of the signal amplifier. It is best to use a quality amplifier that has a variable output so that you can adjust it to match 35 db even if your input is either lower or higher.
Limited Warranty PLEASE READ THESE WARRANTY TERMS AND CONDITIONS CAREFULLY BEFORE USING YOUR CARDIO THEATER PRODUCT. BY USING THE EQUIPMENT, YOU ARE CONSENTING TO BE BOUND BY THE FOLLOWING WARRANTY TERMS AND CONDITIONS. Limited Warranty. Disclaimer and Release. Precor Incorporated (“Precor”) warrants all new Cardio Theater products to be free from defects in The warranties provided herein are the exclusive materials and manufacture for the warranty periods set forth below.
Need help?
Do you have a question about the 15” TFT LCD TV and is the answer not in the manual?
Questions and answers