Do you have a question about the Sparrow I 36” and is the answer not in the manual?
Questions and answers
Summary of Contents for Supermarine Sparrow I 36”
Page 1
Supermarine Sparrow I 36” Supermarine Sparrow I 36” R/C Scale Model Instructions CONTACT INFORMATION The Supermarine Sparrow I was designed by Kurt Bengtson Prototype Builder Mike Stanley Manufactured and Distributed by: Bengtson Company PO Box 51102 Pacific Grove CA 93950...
Page 2
Sparrow I 36” Thank you for purchasing the Sparrow I model for electric flight. BUILDING THE MODEL The new Supermarine Sparrow I was entered into the FUSELAGE CONSTRUCTION 1924 Daily Mail Two-Seater Light Aeroplane Competition held in Lympne, Kent UK. The sparrow The fuselage is built as a unitized box structure, using was flown by Henri Baird on September 11.
Page 3
Supermarine Sparrow I 36” Adding The Undercarriage Plates Once dry, remove from the board and add the 1/8” x1/4” bass wood crosspieces that serve as u/c plates. The Center section with dihedral brace. Stringers and Sanding Add the top stringers before giving the fuselage a good overall sanding.
Page 4
Supermarine Sparrow I 36” WHEELS Gluing the ply sides on the ¼ “balsa core makes the basis for the wheels. Use the brass hub for alignment. Epoxy the hubs in place and add a sufficient amount of epoxy around the base of the hub to reinforce the connection of the hub to the ply.
Supermarine Sparrow I 36” Battery Tray Loops are very comfortable from level flight and predictable, half to a quarter throttle flying is no problem using 8 cell Kan 1050mah and a castle creations Pixie- After all the above has been placed, mount the battery P20.
Need help?
Do you have a question about the Sparrow I 36” and is the answer not in the manual?
Questions and answers