How To Clean And Care For Your Epac - GHOST EPAC Ghost Original Operating Instructions

Pedelec
Table of Contents

Advertisement

Available languages

Available languages

GHOST EPAC
EN

14.2 How to clean and care for your EPAC

WARNING
Danger of Injury
Before carrying out any work on your EPAC, make sure that it is not prepared
for moving off (traction standby). To do this, switch off the electric drive (see
attached BOSCH original operating instructions).
WARNING Danger from falls and accidents
Incorrect cleaning and care can lead to dangerous riding situations,
falls and accidents.
Maintain your EPAC carefully according to the instructions below.
WARNING Danger from falls and accidents
Corrosion - which can also affect non-rusting parts - may damage the safety
components of your EPAC so severely that they break when you are riding it.
This may result in serious falls.
Corrosion can result, amongst other things,
from salty air near the coast or the spreading of salt on the roads in the winter
through a corrosive atmosphere, e.g. on industrial sites through sweat.
Protect your EPAC with spray wax or a similar preserving agent against all
contacts with corrosive substances.
Clean your EPAC after all contacts with corrosive substances and protect it
again in accordance with the following description.
Do not use any steam jet/high-pressure cleaner for wet cleaning. The
strong waterjet may damage your EPAC or cause a short circuit (danger of
fire).
NOTE:
Good care and maintenance increases the service life of your EPAC and its compo-
nents.
Clean and service your EPAC at regular intervals.
Use a gentle water jet or a bucket of water and sponge to clean your bicycle.
Use only clean fresh or desalinated water. Do not use any saltwater
(e.g. seawater)
NOTE:
With many cleansers and moderate soiling it is often sufficient to spray on the cleans-
er and to rinse it off again after the prescribed waiting time.
Stubborn soiling can be loosened after the reaction time, e.g. with a radiator paint-
brush or sponge, before rinsing off.
NOTE:
Cleansers, lubricants and corrosion inhibitors are chemical products. Some of these
agents can damage your EPAC.
154
Originalbetriebsanleitung 11/2014
E - H Y B R I D E A N D A S O L & A N D A S O L X
E - H Y B R I D E T E R U & T E R U FS
Original operating instructions 11/2014
154

Advertisement

Chapters

Table of Contents
loading

Table of Contents