Advertisement
4.
Your stove is now assembled and can be put into place in the
fireplace and connected to the flue system. The internal stove base is
protected with a sheet of plastic – please remove this plastic at this point.
5. The canopy can now be attached to the stove. Take 1 right angle
bracket and using the holes provided, fix the bracket as per drawing to
the side panel and secure with 3 bolts. Repeat this procedure on the
opposite side panel.
Diagram of bracket
6. Place the canopy on the stove resting the base of the canopy on the
right angle brackets. Ensure there is a minimum 15mm gap between the
rear wall of the fireplace and the rear of the canopy to allow the hot air to
circulate.
When satisfied with the position of the canopy, attach each right angle
bracket into the canopy base and secure with the supplied nut & bolt.
7. Attach the base cover to the front of the appliance by sliding the cover
into the gap provided by the leg bolts.
SOME FACTS ABOUT YOUR STOVE
This appliance is fitted with air controls which should be operated as
follows:-
PRIMARY AIRSLIDE
(Located to the right hand side below the doors)
Pushed in = CLOSED
Pulled out = OPEN
SECONDARY AIRSLIDE
(Located to the right hand side above the doors)
Lever to the left = CLOSED
Lever to the right = OPEN
To open the door, point the door handle up. To close the door, point the
door handle horizontally.
6
Advertisement
