Related Manuals for SilentCall SK2-SS Sidekick II Signature Series
Summary of Contents for SilentCall SK2-SS Sidekick II Signature Series
- Page 1 Sidekick II Sidekick II ™ ™ Receiver Receiver Model # SK2-SS Model # SK2-SS 418MHz Signature Series Signature Series...
-
Page 3: Setup And Operation
Sidekick II Signature Series Model # SK2-SS (418 MHz Receiver) Setup and Operation: 1. Plug the power supply pin jack into the connector located next to the Power ON/OFF switch on the back of the receiver. (see page 6 for diagram) Plug power supply into a wall electrical outlet. Battery Back-up Installation Instructions Your Sidekick II Signature Series Receiver comes with the battery back-up pre-installed at the fac- tory. -
Page 4: Setting Alarm Clock
3. Set Clock Time: Press and release the MODE pushbutton (the large button located at the lower right hand side on the unit). The Orange LED will light up to let you know that you are in “Set Clock Time” mode. 4. -
Page 5: Lcd Display
LCD Display: The LCD Display screen is back lighted. The back light brightness is automatically controlled by the light level in the room. When the room becomes dark, the back lighting comes on. When the room becomes light, the back lighting goes off. telephone Direct Interface: The Sidekick II Signature Series Receiver has the ability to plug a standard telephone line directly into the receiver using the supplied telephone wire and dual connector and it will notify you each time the... - Page 6 Remove screw to gain access to battery backup compartment. 2 AAA Batteries Clock Battery Backup Accessory Battery Backup 12V NI-CAD 300mA Compartment & Connector Battery Backup On/Off Switch On/Off Antenna Switch Telephone Power Supply Vibrator Jack Interface Input Terminal...
- Page 7 transmitters When the Sidekick II Signature Series Receiver detects an incoming signal from any of the Signature Series transmitters it will notify you by: Transmitter Type Icon Notification Alarm Clock Bell Icon, Strobe flashes (Vibrator Optional) Sound Monitor Transmitter Sound Icon, Orange LED, Strobe flashes (Vibrator Optional) Telephone Transmitter Phone Icon, Green LED, Strobe flashes...
- Page 8 transmission Range: Transmission range refers to the distance a Silent Call Transmitter can communicate with the Sidekick II Signature Series Receiver. Range is measured in an outdoor environment without obstructions from metal objects or buildings. The range for the Sidekick II Signature Series Receiver is up to 2000 feet. The actual range inside a building will vary depending on many factors outside of one’s control.
-
Page 9: All Erase
11. Repeat the above steps ONLY if the other transmitters are set to a DIFFERENT address setting than the transmitter you just programmed. We recommend keeping all of your transmitters set to the same address to reduce interference from other Silent Call systems that may be in your area. All erase: Provisions are made to erase all programmed transmitter addresses. -
Page 10: Low Battery Notification
Support For technical support on this or any other Silent Call product, please feel free to contact us. You can reach us by phone at 800-572-5227 (voice or TTY) or by Email at support@silentcall.com Limited Warranty Your Silent Call product is warranted to be free of defects in material and workmanship for five years from the date of initial purchase. - Page 12 5095 Williams Lake Road Waterford, MI 48329 Phone 800-572-5227 v/tty www.silentcall.com...
Need help?
Do you have a question about the SK2-SS Sidekick II Signature Series and is the answer not in the manual?
Questions and answers
what kind of signal do i receive from the doorbell and telephone setting.i **** deaf without my aids
For the SilentCall SK2-SS Sidekick II Signature Series Receiver:
- The doorbell transmitter provides two short pulses (••).
- The telephone transmitter provides one long pulse (—).
This answer is automatically generated