Inaxsys COAX2IP User Manual

COAX2IP
10/100Base-Tx Long Reach
Ethernet Extender
BNC
User Manual
Introduction
Long Reach Ethernet Extender with one
Ethernet port (on 1 RJ-45 connector) and one
VDSL port on 1 BNC connector. This is a bridge
mode modem accommodating Ethernet and
VDSL technologies to extend Ethernet over
single-pair phone line by using a VDSL signal.
Up to 100/60 Mbps (or 90/90 Mbps with
synchronous data rate) transition bandwidth
within 300m and 40/10 Mbps for 1km long range
connections provides ultra-high performance to
the pervasive telephone line network. Its
plug-n-play solution minimum installation time &
cost by allowing video streaming and data to
share the same telephone pair
interference.
With one DIP switches configuration, the
product includes the CO (Central Office) site
and CPE (Customer Premise Equipment) site.
The long distance support feature makes this
extender be a great and ideal solution for FTTx
(Fiber to the Building, Fiber to the Campus or
Fiber to the Home) applications. It supports high
bandwidth VDSL2 over existing telephone wires
in the "last mile" from the ISP / Telecom /
Service provider's fiber mode to the buildings
and customers' home.
Key Features
 1 full-duplex VDSL links via BNC
connector
 Selectable CO and CPE mode
 Selectable fast and interleaved mode
 Selectable target SNR margin
 Compliant with ETSI, ITU and
ANSI standards
Front Panel (LEDs)
LED Indicators
LED Status
On RJ 45 port full duplex
Duplex
Off RJ 45 port half duplex
On RJ 45 connect at 100M
Speed
off RJ 45 connect at 10M
On RJ 45 port is link
Link/Act
RJ 45 port Data is
Blinking
transmitting or receiving
On Power is on.
without
Power
Off Power is off.
Work as Master at Core
On
center
CO
Work as CPE at Edge
off
site
Blinking Negotiation
Nego
On Link is connected
/Link
flash
/Act Data Active
Blinking
DIP Switches Mode Configuration
DIP 1
Description
On CO
Off CPE
 Pin 1 CPE or CO mode selection
 Pin 2 Interleave mode or
fast mode selection
 Pin 3 Symmetric ISDN Mode or
998 ISDN Mode selection
 Pin4 Signal Noise Rate selection
for 9dB or 6dB
Package Contents
Before you start to install this switch, please
verify your package that contains the
following items:
 One Long Reach Ethernet Extender
 One Power Adaptor
 One User Manual
Note: If any of these items is found missing
or damaged, please contact your local
supplier for replacement.
2 3 4
Fast 998ISDN 6dB
Interleave Symmetric 9dB