Table of Contents
Advertisement
DG200 Series User's Guide
Enter the Service Provider Name if any
Select the Authentication Method used during negotiation, default is AUTO.
Check to enable Fullcore NAT if necessary
Check "Dial On Demand" if you do not need PPPoE connection always ON and enter
the timeout value to disconnect the PPPoE connection when connection is idle and
timeout. If you enter "0", zero for the timeout value, it means always ON.
Check the "PPP IP extension" if ISP requests to enable it, otherwise do not select it.
This is a special service to forward IP address assigned by remote to the local device in
the LAN.
Check the "Use Static IPv4 address" and enter the IP address if your ISP assigns a
fixed IP address to you. Otherwise, do not select it.
Check to enable "PPP Debug Mode"
Check Bridge PPP frames between WAN and Local Ports if you want to pass PPP
frame between WAN and LAN.
Check to enable IGMP Multicast to avoid the multicast packet flooding to other LAN
ports where do not need this IGMP packet to get better efficiency in Ethernet port.
Check to enable MLD (Multicast Listener Discovery) Multicast Proxy
Click Next to configure the default gateway
Figure 26: WAN Service, Default Gateway
Select a preferred WAN interface from the list as the device default path to route the
packets.
Click Next to configure the DNS servers
Figure 27: WAN Service, DNS Settings
Select to obtain DNS info from a WAN interface or set static DNS IP addresses to enter
IP address of Primary DNS server and/or Secondary DNS server.
Click Next to view the Summary of current settings
22
- Quick Links:
- Features
- Front Panel
Hide quick links:
Advertisement
Table of Contents
