Advertisement
Quick Links
Advertisement
Related Manuals for Panoview Prefessional Cinema Motorized Screen
Summary of Contents for Panoview Prefessional Cinema Motorized Screen
- Page 1 Professional Cinema Motorized Screen Set-up Guide...
-
Page 2: Important Safety Instructions
Panoview of all liability. • Basic electrical safety precautions should always be observed. • In the event, the above mentioned safety precautions are not observed, the warranty may be void and Panoview released of all liability. | Motorized Screen Set-Up Guide... - Page 3 Thank you for choosing Panoview screens. All screens have passed the strict quality inspection before delivery. Read this manual carefully to ensure proper usage. Important Attention: The installation of the screen, the electric wire connection, the setting of the limit switches must be made by a trained technician only.
-
Page 4: Installation
Care in mounting and care in correct operation will mean a long and satisfactory life for your Panoview screen. Locate the screen where the audience can best see it and where other furnishings in the room permit. -
Page 5: Electric Connection
Internal wiring has been completed at the factory. No additional wiring is necessary. Note: All wiring related to the screen, may only be serviced by a manufacturer approved trained electrical technician. Tampering with electrical wiring may void warranty and release Panoview of liability. BLACK(DOWN) RED(UP) WHITE... - Page 6 OPERATING INSTRUCTION: Remove two pulling locks on the bottom bar first before any operation. this is important to prevent motor damage. Plug in power supply. For Switch control: Plug in Switch into switch jack. Press button to Up position, screen goes up. Press button to stop position, screen stops. Press button to down position, screen goes down.
-
Page 7: Screen Adjustment
SCREEN ADJUSTMENT Note: Adjustments to screen limit positions, can only be performed by a trained technician. Screen travel is stopped automatically in the down and up positions by limit switches that are preset in the factory. If it Is necessary to adjust for more or less, please follow the steps below for adjustment. - Page 8 SETTING THE DOWN LIMIT POSITION To reduce the screen drop: Make sure middle fastening screw (F) is loosened, then loosen small right fastening screw (FR), Turn right screw ( RS ) counterclockwise to decrease the amount of screen drop. Run the screen down to test the stop position. If the screen drops too far, adjust the limit switch again.
- Page 9 SETTING THE UP LIMIT POSITION CAUTION: Do not allow the slat bar to become wedged between the roller and case. This could damage the fabric and motor. Always check that the slat is free to move inside the case. If the screen travels too far into the case: Make sure the middle fastening screw (F) is loosened, then loosen the small left fastening screw (FL).
- Page 10 Canada 5630 Kennedy Road Mississauga, ON, L4Z 2A9, Canada Tel: 905-882-4228 Fax: 905-882-4229 www.optoma.com 715 Sycamore Drive Milpitas, CA 95035, USA Tel: 408-383-3700 Fax: 408-383-3702 www.optomausa.com Optoma Technology, Inc. 715 Sycamore Drive, Milpitas CA 95035 Tel: 408-383-3700 • Fax: 408-383-3702 For more information, please visit www.Optoma.com.