Table of Contents
Advertisement
seropt
This command enables the user to select from several serial protocol options.
Command format:
where: s =
Upon receipt of serial characters, the modem strips the parity bit, sends the data to the
remote device where the parity bit is regenerated if parity is enabled at the remote.
This makes it possible to run parity at one end and no parity at the other end of the
link.
ping
Please refer to chapter 4 for an overview of the ping function.
Command format:
where: n =
radar
Please refer to chapter 4 for an overview of the radar function.
Command format:
where: n =
User's Guide
DTE serial options
ping [s]
8n1
Sets 8 data, no parity and 1 stop bit.
8n2
Sets 8 data, no parity and 2 stop bits.
8o1
Sets 8 data, odd parity and 1 stop bit.
8e1
Sets 8 data, even parity and 1 stop bit.
Ping test
ping [n]
[0-15] Optional unit number to ping. If not specified the current unit
number is used. The site address used corresponds to the value
set using the site command.
Radar test
radar [n]
[0-15] Optional unit number with which to perform the radar test. If not
specified the current unit number is used. The site address used
corresponds to the value set using the site command.
Configuration Commands 3-11
Advertisement
Table of Contents
