di-GPS Eco ProSumer PS10-M User Manual page 8

CONNECTING ECO PS10-M GPS TO CAMERA
Connect the DSLR camera and Eco PS10-M GPS as described below.
1. Turn off the camera.
2. Remove the cap from the accessory terminal on the camera body.
3. Attach the Eco PS10-M GPS directly to the accessory terminal on camera. Do not use any
extension cord.
4. Switch the power mode to "On" or "Auto".
5. Turn the camera on.
6. If Eco PS10-M GPS is properly connected, the camera will display a blinking icon on the top
control panel / LCD monitor of DSLR camera. It means Eco PS10-M GPS is searching for a
signal. The icon will stop blinking once signal has been established and Eco PS10-M GPS is
ready for supplying the current position.
7. Eco PS10-M GPS will automatically detect the connection of the camera. It cannot be turned
on when the camera is not connected whatever the power mode switch is set to "On" or
"Auto". Both "On" and "Auto" mode only function when the camera is properly connected.
DI-GPS® IS A REGISTERED TRADEMARK OR A TRADE MARK OF DAW N TECHNOL OGY LIMITED.
NIKON D2HS, D2X, D2XS, D200, D3, D3S, D3 X, D300, D300S, D600, D700, D800, D90, D3100, D3200, D5000,
D5100, D7000, D7100 AND P7700 ARE REGIST ERED TRADEMARK OR A TRADEMARK OF NIKON
CORPORATION IN THE U NITED STATES AND/OR OTHER COUNTRIES.
FUJIFILM AND S5 PRO ARE REGISTERED TRADEMARK OR A TRADEMARK OF FUJIFIL M U.S.A., INC. IN TH E
UNITED STATES AND/OR OTHER COUNTRIES.
V1.02
7