Important Safety Instructions And Precautions - Mitel Wireless LAN Stand Installation Manual

Federal Communications Commission (FCC) Compliance
Notice: Radio Frequency Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
This equipment is limited to operation on channels 1 - 11 when
NOTE:
configured for use in the USA.
Changes or modifications not expressly approved by Sigpro LLC may
NOTE:
void the user's right to operate the equipment.
RF Exposures
This device has been evaluated under FCC bulletin OEC65C and found
compliant to the requirements as set forth in CFR47, section 2.1091 and
15.247(b)4 addressing RF exposure from radio frequency devices.
WARNING:To ensure compliance with FCC and IC RF exposure
requirements, the antenna used for this device must be installed
to provide a separation distance of at least 20 cm (8 in) from all
persons.
Canadian Compliance Statement
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with Class B limits of Industry of Canada. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference
that may cause undesired operation.
This device complies with RSS-210 of Industry Canada. To prevent radio
interference to the licensed service, this device is intended to be operated
indoors and away from windows to provide maximum shielding. Equipment (or
its transmit antenna) that is installed outdoors is subject to licensing.
Notice to Customers in EU Countries
Sigpro LLC
Guest-Tek International Group
44 Watchfield Court
Sutton Court Road
Chiswick, London
United Kingdom
W4-4NB
+44-(0)2091 416 928
Declare that for the hereinafter mentioned product the presumption of
conformity with the applicable essential requirements of
DIRECTIVE 1999/5/EC OF THE EUROPEAN
PARLIAMENT (RTTE DIRECTIVE) AND OF THE COUNCIL
Mitel Networks Wireless LAN Stand
Any unauthorized modification of the product voids this Declaration.
For a copy of the original signed Declaration of Conformity (in full conformance
with EN45014), please contact the Regulatory Approvals Manager at the above
address.
This device is restricted to indoor use when operating in France.
NOTE:

Important Safety Instructions and Precautions

WARNING:
DO NOT CONNECT DIRECTLY TO THE PUBLIC SWITCHED
TELEPHONE NETWORK (PSTN). ANY CONNECTION OF THIS UNIT TO
AN OFF PREMISE APPLICATION, AN OUT OF PLANT APPLICATION,
ANY OTHER EXPOSED PLANT APPLICATION, OR TO ANY
EQUIPMENT OTHER THAN THE INTENDED APPLICATION MAY
RESULT IN A SAFETY HAZARD, AND/OR DEFECTIVE OPERATION,
AND/OR EQUIPMENT DAMAGE. "EXPOSED PLANT" MEANS WHERE
ANY PORTION OF THE CIRCUIT IS SUBJECT TO ACCIDENTAL
CONTACT WITH ELECTRIC LIGHTING OR POWER CONDUCTORS
OPERATING AT A VOLTAGE EXCEEDING 300 V BETWEEN
CONDUCTORS OR IS SUBJECT TO LIGHTNING STRIKES.
WARNING:
ONLY MITEL NETWORKS APPROVED AC POWER ADAPTERS SHALL
BE USED.
WARNING:
THE SOCKET OUTLET, IF USED, SHALL BE LOCATED NEAR THE
EQUIPMENT AND SHALL BE EASILY ACCESSIBLE BY THE USER.
WARNING:
THE MITEL WIRELESS LAN STAND IS FOR USE ONLY WITH
SPECIFIED MITEL EQUIPMENT.
When using your phone equipment, basic safety precautions should always be followed to
reduce the risk of fire, electric shock and injury to persons, including the following:
• Do not use this product near water, for example, near a bath tub, wash bowl, kitchen
sink or laundry tub, in a wet basement or near a swimming pool.
• Avoid using a phone (other than a cordless type) during an electrical storm. There
may be a remote risk of electric shock from lightning.
• Do not use the phone to report a gas leak in the vicinity of a leak.
These notices may appear on the product or in the technical documentation:
Danger indicates an imminently hazardous situation which, if not
DANGER
avoided, will result in death or serious injury.
Warning indicates a potentially hazardous situation which, if not
WARNING
avoided, could result in death or serious injury.
Caution indicates a potentially hazardous situation which, if not
CAUTION avoided, may result in minor or moderate injury and/or damage to the
equipment or property.
This symbol may appear on the product:
The exclamation point within an equilateral triangle indicates that important
!
operating and maintenance (servicing) instructions are included in the
literature accompanying the product.
is given.
3